for a stick shift jk is an auto ecu needed if you have Hp tuners and can switch the config to Auto ?
@reidhulshof36459 күн бұрын
For a 5.7 paired with a NAG1, is the torque converter included in the kit? If not what would you recommend and where would you recommend finding it
@tylerhenschel-qb9js10 күн бұрын
Could you just use a transmission from a 8-speed jl or jt? Instead of the ram truck.
@buddyluv420011 күн бұрын
Did you buy the bolts?
@Lammons196012 күн бұрын
Why would you use the truck transmission vs the 8 speed and transfer case in a JL or JT? I have a 2021 Gladiator and a 2017 JK 2 door. I am wanting to find a wrecked or damaged JT and use the drive train in it. Since they use the same motor and such I was hoping it would bolt up and very little mods? has anyone done this? is the truck tranny stronger? My JK is a toy and I am wanting to have the same pep the JT has. World of difference. Is there a one stop shop source to this information. Thanks in advance. Larry
@Crucial92919 күн бұрын
damn ... i have a 14 manual that i would loooooove to have a auto trans in ... the 8speed would be that much better ... guess i need to start saving my pennies ..
@GoProHeroVideos20 күн бұрын
How do you mount the jl cooler on the jk?
@OliverParedes-uq5vr27 күн бұрын
Can i swap in at 2021
@hoganfan92428 күн бұрын
Would the broken sensor tip cause: “TCM undetermined clutch fault?” & “Clutch 2 fault?” I swapped in a new 845RE into my Durango, and that sensor tip was broken off from the old TCM (but swapped in to the new donor trans). As soon as I start driving, it jumps into 6th gear limp home mode when it does the 2-3 shift. Thanks, not much of this info out there other than your video. Alex
@nicholasnapier2684Ай бұрын
I got a question for you if you get a chance to answer it I want to know where the input speed sensor for the transmission is. I’m looking under the JK right now 2018 and I’m looking to see if I can fix this on my own plug-in play.
@assassin0117Ай бұрын
Will this swap work on 2dr jks? (2013 jk auto 2dr)
@jeepspeedshop23 күн бұрын
Yes it will, we have done it on many 2 doors. The 8 speed will work on any 2012-2018 Jeep JK with the 3.6L and it does not matter if it is for a manual or a auto transmission Jeep JK. The 8 speed will work..
@alejandrovictoria5424Ай бұрын
Is this a 2008 JK with the 3.8 or Hemi?
@austinfouts9139Ай бұрын
Couple questions. Will the 2010 grand cherokee 5.7 accessory drive bolt up to the 6.4 and if i send you a 6.4 intake can you modofy it like this one for me?
@jeepspeedshop23 күн бұрын
Yes the 2009-2010 Grand Cherokee 5.7L accessory drive will work on any VVT Hemi engine. We build the 6.4L intake from a new intake manifold..
@alijameel2050Ай бұрын
Hi, is your controller compatible SPAL PLUS SERIES - Choose "Device Select" 1 from the data sheet since your device is built for Jeep speed shop. can I change the 30% A/C Trigger, for example 40% because of high temperature I need a good performance AC.Could you please help me with this?
@JWard2Ай бұрын
Hell yes
@jeepspeedshopАй бұрын
BIG improvement..
@chrisbrattonАй бұрын
Waiting on 2023 5.7 to come in. Is it worth selling all that crap? Do you have digital list of all the parts I need to order?
@jeepspeedshopАй бұрын
I do have a list, I'm not sure about who would buy the parts
@xoxokisses639Ай бұрын
Looking for ground wire on 2014 Dodge ram 1500 with hemi
@kenberscheit948Ай бұрын
too bad the engine running ruined your video
@jeffdurling1002 ай бұрын
Only other question. Is there any reason to not go with the 8HP70 or 8HP75? Seems like they can be found a little easier and slightly less money. Thanks.
@jeepspeedshopАй бұрын
Just can not bolt it up to a 3.6L
@jeffdurling100Ай бұрын
@@jeepspeedshop I was not aware. Thanks for the info.
@tommyjohnson14552 ай бұрын
How about an e-torque on a jk? Just wander if it would be advantageous.
@jeepspeedshop2 ай бұрын
Do you mean have the e-torque work, i could not see how that would work and have the Jeep JK function..
@thatmar1neguy2 ай бұрын
3 questions I have for ya Is the 8spd from a 392 different in the gear setup? What does a swap like this cost? You referenced smog sooo is your shop in Cali?
@carlosmorales51012 ай бұрын
TODD is the best!! You need to start making videos about the rigs you build like those offroad channels. Woud you guys ever make a 5.7L Hemi & 8 speed install series?
@jeepspeedshop2 ай бұрын
Something we think about and it is on the table one day..
@christucker63152 ай бұрын
Do you have to do anything with the driveshaft?
@jeepspeedshop2 ай бұрын
The stock JK drive shafts work, now if you have aftermarket shafts you would need to look at the slip yoke and see if you have 2 inches of room..
@alijameel20502 ай бұрын
Hi, what is the Dip switch position
@alijameel20502 ай бұрын
How to set the 30% for the AC?
@dr.gintoki82062 ай бұрын
Todd can I go first with the 8speed swap after that going for the v8 on with your kits?
@jeepspeedshop2 ай бұрын
So the transmission we use with the V6 is a 850RE and the 845RE and that will not work in a V8 because you will need a HP70 or a HP75. But all the rest of the 8 speed swap will work.. Like the wiring and module, shifter, mounts..
@ricwilliams28762 ай бұрын
Could you use your knowledge and hook up a BMW M57 engine?
@theamaturepro2 ай бұрын
I was bolted onto those points and in mid air one of the rear ones busted out. Chipped the whole rear corner of the head off where the ground strap goes. Luckily it didn't start any cracks or damage anything towards the block so I ran with that head and it's been doing fine for a few years. It was a brand new engine i had just built! I don't recall exactly what I said when it happened, but I'm sure Jesus wasn't thrilled. Lol
@TheDustyamanАй бұрын
Did you use grade 8 bolts to do this? If you just use a basic bolt it doesn't have the tensile strength to hold that weight.
@alijameel20502 ай бұрын
How to set the 30% for the AC?
@jeffdurling1002 ай бұрын
Does this fit in a 2-door 2013 JK? Making sure that the longer transmission, with the 2-door, is not a problem. Know of any shops that can do this work anywhere? Also, do I still go with the same gearing I am planning on in my axels? Planning on 4.56 and running 35x12.5 all around. I've driven a Grand Cherokee with this setup from the factory and the 3.6 is completely different. Peppy, keeps good highway speed, plenty of power around town, etc.
@jeepspeedshop2 ай бұрын
We have done many 2 doors with no problem, the 8 speed in a JK is a big bonus and that is a good gear setup for 35s..
@alijameel20502 ай бұрын
Hi, what is the Dip switch position
@HEMIproject2 ай бұрын
I would like to do this conversion on a 2012 Ram 1500 5.7L, currently has the 65RFE. I have seen some guides online that make it sound like a aftermarket TCU is required. Would the process for the Ram be similar to your jeep?
@larrylawrence22222 ай бұрын
No body lift?
@karanrandhawa65682 ай бұрын
Hy i did the swap already for my WK2 grand cherokee to a 6.4L hemi i am also looking for oil cooler as oil temp is heating mine 5.7 comes with a adapter and one more question were does both hoes goes to in and out for the oil cooler. Much appreciate
@milijara96342 ай бұрын
Can this be done with a 3.8 2011 2 door jk?
@jeepspeedshop2 ай бұрын
Sorry we can not do a 8 speed swap on a 2007-2011 Jeep JK
@Radjoser2 ай бұрын
Is this carb legal?
@jeepspeedshop2 ай бұрын
Yes, doing a 8 speed swap does not effect the emissions and no engine programming is needed..
@RadjoserАй бұрын
Awesome, thank you. So both the 845 and the 850 will line up with the 3.6? I was going over the BOM on your site and only see the 845 listed. Also, i see that there are 845res and 845rfes. Is there a difference between these?
@00ninja002 ай бұрын
Overall, daily driving and driving to and from trails overlanding etc, which hemi is best to swap into our jk/jl, the 6.4L or the 5.7L? Which is more reliable, less issues overall?
@zachhosmer92082 ай бұрын
Would a 6.4 out of a truck work with your kit? Id imagine youd still have to swap some of the accessory drive. But probably not the intake correct?
@jeepspeedshop2 ай бұрын
We are working on that and have been involved in 2 6.4L truck Hemi swaps, I think the truck Hemi is the best choice for a Jeep..
@yjoem13 ай бұрын
What’s the difference between the 850 and the 870 which is better?
@jeepspeedshop2 ай бұрын
I don't know of a 870, I only know of the 845RE and the 850RE i like the 850 better.. They are both great transmissions
@hemi.2103 ай бұрын
Will this work with a 06 dodge charger
@jeepspeedshop23 күн бұрын
Yes the 8 speed would work on a 2006 Charger..
@christopherwebb61333 ай бұрын
So much want.
@jeepspeedshop2 ай бұрын
It does make a big difference in gas mileage and power
@TheRightLine3 ай бұрын
With the length difference, what are you doing for driveshafts?
@TheRightLine3 ай бұрын
Ah ha, I just saw found the video you mentioned about converting the tcase to a manual input for the 8 speed swap.
@TheRightLine3 ай бұрын
So, 14' auto nag1, Rubicon tcase, will bolt up to the 8 speed 8hp50?
@jeepspeedshop3 ай бұрын
Yes but you will need to convert it to a manual t case..
@TheRightLine3 ай бұрын
@@jeepspeedshop I heard that in the video then I thought I heard you say the Rubicon case had the correct input.
@308Reaper3 ай бұрын
What the price of your kit with the exhaust?
@jeepspeedshop3 ай бұрын
The wiring/module/floor plate with spacers $1500, plate B $50,00, bezel $50.00, Exhaust $450
@14Maxmom3 ай бұрын
With this swap, is there any sort of PCM/TCM flashing if you already have a 12-18 auto?
@jeepspeedshop3 ай бұрын
I do not have one for the Nag1
@toddoverzet28803 ай бұрын
Thx Todd! Appreciate the video. Looking forward to getting the swap done.