all that water went everywhere because you did not drain hose enough

Thank you po, you helped us clean our machine! Couldn’t figure this out ourselves

Rosary beed cannot help. It’s not in the HolyBible.

Does anyone know what happens if I’ve done this and it’s still not working

I watched two other videos before this one and yours was the only one that vividly showed how to pull the the light bulb out of the wiring. Thank you sir

How to count on coelpacks

Hi, how do I fix a noisy machine when spinning? Thx.

Can someone please answer this question: is it normal to have residual gunk in other crevices surrounding the filter? I can take out the filter but there is a cavity inside the hole where the filter goes and that cavity is full of gunk. I can use my finger to slide some out but I don't know how to remove the front panel to get to all of it 😢

In my parents washing machine a piece of plastic was jamming up the pump which was causing code 37 to be set!

I did that but there's still the same error message 😢

Awesome, thanks!

Brilliant - Had no idea what was wrong and how to fix, but this was so easy, washing machine working properly again - GAME ON!

Thx Dad !!

This model is nightmare, only three years old and all the little bits all over washed clothes, lindt everywhere

Thank you!

Done it a few times still saying clogged?

Awesome thank you!

fixed - use a shallow oven tray to catch the water and after puliing the filter out check inside too i found something blocking the impellor blades - thanks

I couldn’t open by coin.

I cleaned the filter, it still gives my the alarm. Any ideas?

Thank you thank you thank you

Thankyou very much for the helpful video, Champion!👍

Hi, Thank you for the informative video. After changing the spark plugs in my Pajero the car does not crank or start, what might be the cause? Thank you from Australia.

Hey does the spanner have toyota engraved in them

Did all that and it's clear. I think it's the outlet pipe that isn't clearing. When blew in it, it feels blocked a bit. Any ideas?

Yo tengo una y me fascina

A tip for anyone, especially newer DIYers. Get a piece of cardboard, put a "F" on one end, poke seven holes starting near the "F" and make the holes in a row with a couple inches in between them going away from the "F". Remove the front intake bolt and put it in the first hole closest to the "F" (front) then as you work your way back out each bolt on the next hole on the cardboard. This way you never mix up any of the intake bolts. Works good for head bolts as well.

Thank you so much this was super helpful.

Cant even remove mine smh

I suggest using the spanner that came with your machine to undo the filter it will save you a lot of pain!!

Thanks mate, broke my washing machine

ZERO water came out of the tube, but literally buckets of water came out where the filter is and flooded the laundry floor. Terrible design.

You da Man! I watched your video and it worked like a charm! I ended up having to remove the larger part of the rubber hose and sure enough there was a casino type chip and of course tucked in behind it was a 50 cent coin! Thanks!

Would never recommend this washing machine to anyone

Exactly what I needed to see... Thank you

You guys saved me thanks a lot

Thank you for sharing this. It's the second time in a row that a stupid face mask has clogged our filter. Bad enough we had to wear the ridiculous things, but to run the risk of having to pay hundreds of dollars to get our machine fixed because one of them got stuck would have been the last straw.

Thanks u so much

I cange all and no one working anny help what to do?

hello....can you tell me what the white plastic round ring is that is hanging in front of filter???

Quick video, covered everything. Made it easy. GAME ON!!!!

Yep, you da man!

Great Video. Did you see this one? Fisher Washer Error Codes kzfaq.info/get/bejne/gql8eZths7yYeJs.html

HI DIY Dad, did you turn the machine off at the power point before doing this job? I'm hoping that is not necessary, as our power point is pretty inaccessible.

Thx for this, I have anoterh issue, it says out of bal, can you let us know how to solve it?

No water comes from the hose on mine, only when the filters opened abd heaps comes out.

Thank you!

Thank you!!

Does this fit into sport swap? The engine I mean 3.8 into 3.0 sport

You absolute legend! Thank you so much for sharing this, appreciate it. Just fixed the washing machine and it is running this load again. Mine was a coin!