CPE Pressure Vessels Limited

Пікірлер

@ghislainfelix6022 11 ай бұрын

Bonjour. Vous avez réaliser le projet que je voulais réaliser. (mon rêve) Merci. Ghislain

@ryanhardy8915 Жыл бұрын

*Promo SM*

@itsmeagain7825 Жыл бұрын

A fantastic piece of work! Did "mad mike" have anything to do with the concept?

@Soapypoo Жыл бұрын

Oppreser MkII

@kia_lio Жыл бұрын

Hi , how we can use light lamp in pressure vessels ?

@SophiaDuan-yx7vt Жыл бұрын

The work is really amazing, it would be even better if we can use our flange products.

@krzysztofmierzejewski2882 Жыл бұрын

In fact this is not a pressure vessel at all. 10 Bar is not a big pressure. It is just a vessel. With all the pressure tests and RTG/Ultrasonic testing that would not take that amount of time but far more, especially when You would count welding sheets above 10 mm with MIG/MAG.

@yesisiliofa7592 Жыл бұрын

Kkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkk.

@PrinceDS 2 жыл бұрын

Incredible Work 👏👏😍

@jd4000 2 жыл бұрын

I'd like to see a more detailed video of how you make these, especially the welding part!

@tarunrgu 2 жыл бұрын

How much does this cost like a range and estimate?

@reconb20 2 жыл бұрын

It's fantastic! Congratulations! Respect for engineers! I have a few questions: 1. what is the wall thickness of the main cylinder? 2. Are the bottoms of the cylinder and the central cylinder made separately? They are in different colors in the video... 3.And through which pipe do you load the water? 4. If you make a cylinder from 4130 stainless steel, and electrochemically coated with nickel from the inside, would it be cheaper than 316L steel? 5. The mass flow rate, based on the active engine running time of 3.5 seconds, (if you watch the motorcycle start video), is 50 liters cylinder volume / 3.5 seconds = 14.8 liters per second, right? The average impulse of water vapor at 250 degrees Celsius = 50 seconds. Average thrust = 14.8 x 50 = 740 kg, or 1629 pounds? Or did you fill the balloon at 80% of the volume? Thank you so much for the video, and the work done, very, very cool!!!

@CPEVessels 2 жыл бұрын

Thanks, have a look at the projects facebook page, your questions would be best directed to Graham. facebook.com/pages/category/Personal-blog/Force-of-Nature-Steam-Rocket-Bike-158182478193917/

@Then.72 2 жыл бұрын

Where was the inspector? You must have an ASME inspector watching the welders during the construction of a pressure vessel

@CPEVessels 2 жыл бұрын

Hi, please note this is just a small sample of clips from the production, this project wasn't to an ASME Design code so didn't require inspectors to witness the welding, see the following link for more details on this project. www.pressure-vessels.co.uk/projects/28500-litre-surge-vessel-for-uk-water-industry/ We do manufacture to ASME with U designator but they only witness certain stages of production. we generally cut these parts out of the time lapses. Thanks,