Question for all: How many mile can a 99 Civic engine last if it’s pretty well taken care of?

Thanks for the video, I have a Kia Rondo 2016, is It the same bulb reference ?

I was going to use my hammer rubber Hammer Of course

Olhh man you are the best

I changed the relay and nothing is happening, no flasher no signal lights. Dead as it could be and i can not drive the car with no signals

really dumb question but do you know where i can find the safety clip? mine is extremely worn and about 3x the width of a new one.

I had p0420 sensor 1 bank 1code I filled premium fuel in my turbo 1.4 cruze Code gone and not coming back since 2 months but still there is emission warning Should I replace this upstream sensor sir?

Any idea for the pin at 3:30 mark we can’t get it back in for some strange reason

I think with the recirc flap out there will be a steady stream of outside air coming in from the outside and then through the place where the door used to lay blocking the place behind the glovebox. When the car is moving fast down the highway or has a headwind blowing at it. If the system is right the door blocks the outside air coming in OR blocks the recirc place behind the glovebox. Preventing a chilly draft in winter or a draft of hot humid air in summer even when the air conditioner is running. I wish I knew a way to stop electricity from getting to the actuator motor that makes that door move back and forth trying to break it every time you turn the car off. I wish you could just put the thing one way or the other and unplug the stupid motor that always messes with the door position even if you don't push the recirc button. (I know how to unplug the wire to the front blend door motor and have mine juryrigged so the front blend door motor turns the back blend door also,the back door motor just spins not turning the axle anymore. I put a one piece metal axle in there.) I hook up the wire to change it to hot or cold and then unhook the wire so the motor won't burn up.

Thank you! However my fuse is fine but the rest of the unit is dead.

there's 2 fuses in the fuse box under the hood 15 amp fuses number 2-10 it clearers the Ecm computer in the car of any codes

gracias buen hombre thanks good Men

Great video. Thanks for the help. 05 malibu here.. running rich. Cleaned MAF and throttle body and it helped startup and stalling issue but still have the 02 code which is the main problem. Going to try this out

I have a 2013 Accent. My left turn signal flashes really fast (at a normal rate in rare occasions). I replaced the turn signal bulbs but the problem is still there. Could replacing the flasher fix the problem?

Is there an installation video?

Hey man I think I'm having same problem but I have a 2000 year and there's very little air blowing out vents , no floor or defrost or dash vents , blower runs and all but it's like something is blocking the air flow to vents , could this be same problem?

Can’t even take off da coil wires

thank you. very helpful, you make it easy and simple

Did you have to program it?????

What the fuck is going on here. Words every jeep owner knows well. Thanks for the video.

Did that fix the problem for good? Or did the engine light come back on? I thought 02 sensors had their own different code

HOW Did You remove the Escape Valve where you attach the tip of the coolant (recovery) hose?

Loved the ending

I swear the f ing quick lube my mom uses glued it back on. It’s not giving at all

Very helpful thanks man

Thanks dude

Do you have to empty coolant to change that bleeder hose?

Good video, very helpful. I hope you will make one on installing the control arm.

I have a 2014 Chevy Cruze with 1.4L engine it has 180,000 mile. I have been getting a P0420 code. I would go away and come back. Before replacing any parts try this. I fixed it just by disconnecting the Negative side on the battery 1st. Now find the computer it’s on the side where the battery is. It’s has 3 connectors on it. I disconnected all 3 connectors and cleaned each side male and female connector with CRC 05103 QD Electronic Cleaner. Let it dry 15 minutes. I plugged all 3 back in. I installed negative battery cable. I started and drove the car 50 miles. Update The P0420 came back 2 days later. I will look at the O2 Sensors next.

So for my Chevy Cruze that same thing broke but from a different spot and I see that you have a valve that connects well the holes I had had the same valve already connected on the hose so like if I try to put it on with the that valve on the cruise it basically wouldn't fit so I had to take that valve off to push it in all the way and then it fit so I don't know if I did it wrong I'm just confused right now

2015 rondo and I was ready to break something....thanks for the tutorial. All fixed

may be sensor2?

Hello P0420 error code is only for bank1 sensor 1?

Thank you very much for your video it helped me a lot

Hahaha I was hoping for a better ending.. 🤣

Do you neef to programming the ecu?

Did you buy the ecu used?

Thanks! I couldn't find it anywhere and it was driving me nuts, got it now! Thanks again! Vince Ehyaa!

nice, i saw other videos and they went at it by removing the oil filter and it looked like a pain. this method seems so much easier to reach thank you. more taking apart but id rather skip the frustration of tight spaces

Ok. Ok😘😘👍👍👍

Did this fix the PO420 code?

Did you have to follow any sequence for ECU relearn?

Como traduzir para português Brasil

many years ago I switched from Dexcool to VW G12++/G13 and since then no more plastic parts of the cooling system failed anymore

I did this. Normally when the engine shuts off the vacuum causes the flap to shut. That keeps rain out of the floorboards. No flap big problems

What about a 2019?

Cool

Did it solve the issues??

Thank you!!!