How does our earth still look round-what is the reason must be a volcano was here
@user-nz6im7wv8k2 ай бұрын
Eu tenho bastante fragmentos desses aí que eu presenciei a três anos atrás moro no Brasil cidade de Arujá interior de São Paulo help estou recolhendo até hoje pedaços espalhando nas ruas do bairro estão falando que sou louco 😢😢 help 🎉😢 tenho provas suficiente pra fazer a diferença socorro help
@captkenbad3 ай бұрын
Take off engine shield guard on motor makes doing wires a whole lot easier!
@thors-hammer13 ай бұрын
Wht would BMW try and reinvent the position of the signal lights instead of following what we're used to? Sincerely Stupid in my opinion!
@cabinetmaster444 ай бұрын
This video is terrible
@stanhudson28025 ай бұрын
The attachment spot is too high. Puts too much stress on the plow bracket, I’m worried it’s going to bent too easy. When I put blade down to plow snow it won’t go back enough and blade digs in too much.
@JosephMoralez-oo2ud6 ай бұрын
Thanks for your video, I bought a used one that is in need of repair and I am addressing some of your same issues.
@brianolson12117 ай бұрын
these attachments are all over north america, here in canada every auction has at least 50 tmg products, none with any quality. They are all made in china and north americans are buying them because they are cheap .
@mikeoniones6677 ай бұрын
Horse meat ??
@thegoldenrock75937 ай бұрын
thx
@Brooki3Monst3r9 ай бұрын
I’m planing on doing a metal roof on our awning just like yours. We have the same frame structure. How is yours holding up? Also, does the metal make it overly hot under the awning? What’s your experience when it rains or hails? Anything you would do differently?
@Brooki3Monst3r9 ай бұрын
Curious, What does it sound like when it rains?
@joeybobbie19 ай бұрын
Hi again, You can also go up a Toothe on the front Sprocket to a bigger one. That takes care of the First Gear issue and you don’t really lose any Top End Speed.
@joeybobbie19 ай бұрын
You can get stiffer Springs for the front Shocks. And try adjusting your Damper and Rebound on your rear Shock for better off Road performance.
@anirbanguha7894 Жыл бұрын
Amazing Mountain..
@trpacman Жыл бұрын
Can ya smack your lips anymore, especially after you finish talking ...
@Taahmim Жыл бұрын
lots of common metal oxide in one video
@TheOutFitPropertyMaint. Жыл бұрын
How does it tilt for ditching?
@ndayambazepeter7306 Жыл бұрын
I have the real stone
@charilynadajar8216 Жыл бұрын
Anoya mahal Bayan .nga bato
@christiansmith-of7dt Жыл бұрын
America totally sucks
@nidhinvaishnavi6594 Жыл бұрын
Great 🎉😂
@dailyvideos993 Жыл бұрын
🤔🤔How is this stone?? kzfaq.infoq3qKVMvu3xc?feature=share
@melvarnio Жыл бұрын
I've had the same tent for 15 years. I've rough camped all over Alaska, Canada and several states in the lower 48. It's still going strong 😊
@jyienger Жыл бұрын
Any idea how to adjust the springs. I got one of these units and the springs are so weak it tips over. How to tighten?
@troyboyd3100 Жыл бұрын
I had that same problem. To tighten just thread the large nut at the bottom of the spring rod. I found that curling the "bucket" back a bit, so the lead edge was a little higher, made a big difference. It took some learning to figure out how to use it efficiently, but it was pretty good once I got used to it.
I just inherited tools used by BIW to build war ships. Very old delta stuff. Delta slo-speed metal drill press and a bunch of cool stuff I know little about. All super sturdy cast iron pully type stuff that still works. The table saw rules.
@troyboyd3100 Жыл бұрын
The siphoning thing works great with this setup. Make sure you know that the entire 20L will fit in your tank, then you can get it siphoning and walk away. It takes 10 or 15 minutes to empty the jerry can.
@charlit9989 Жыл бұрын
The second one doesn’t look green looks yellowish
@spotmom Жыл бұрын
Can't play your video, says you have disabled playback on other websites, will play on KZfaq only, but I am on KZfaq and when I click the link in the video to go to youtube same error message.
@troyboyd3100 Жыл бұрын
I made the initial two still images, 5 second each. I think that was too long... The video plays after that.
@rcytb Жыл бұрын
A wealth of good information here. I'm restoring an antique sickle bar mower that belonged to my Dad. The cutter bar had broken, and so, I was in the process of removing all the sickle blades. I tried grinding off the rivet heads and punching them out, but that just was not working well. So, I went to KZfaq and found your video! If my Dad was still alive, he would have taught me what you just did, but he isn't and so, I'm grateful to you and all the KZfaq folks who share their knowledge. THANK YOU!
@mikelong9638 Жыл бұрын
Great straight forward video. Great samples.
@halcooper3070 Жыл бұрын
Why'd you cut off, GV ends after the next dip and rise :) I wanted to see my old house up on the hill :)
@aaronj8600 Жыл бұрын
Cost?
@troyboyd3100 Жыл бұрын
I won the bid with $2200, but there were taxes, and the buyer's premium that RB auction charges.
@BurchellAtTheWharf Жыл бұрын
And add 1/2-1 inch of fiberglass and you have a nearly indestructible vessel, would love to have one like that
@DocRossmore Жыл бұрын
wow. cool
@HoboMinerals Жыл бұрын
I’m so glad I know what horse meat looks like now 🤢🤮
@shefketnebi3752 Жыл бұрын
Ja sam iz makedonia skopje imam sekakov kristal meteor dijamant a drzava ne daje da gi das na javnost odma te zatvaraju i ti uzimaju
@jaenjaen886 Жыл бұрын
Subtítulos en español por favor
@frankanddanasnyder3272 Жыл бұрын
That is asurite mixed with too other minerals...
@whyneedacoolname Жыл бұрын
Your bike seems familiar... You still ride by there often?
@blunosr Жыл бұрын
Yup, all the time. I'm from Masstown.
@whyneedacoolname Жыл бұрын
@@blunosr That's awesome! I'll have to wave if I get to see yeah again.