2003 - 2009 Toyota 4runner Amp and Sub Install

Рет қаралды 12,613

Жыл бұрын

Parts used linked in the description below!
Watch a full tutorial as a 2008 Toyota 4Runner will have a powered subwoofer by Rockford Fosgate installed. We will be using a new Rockford Fosgate P300-12 subwoofer which is rated at 300 watts RMS / 600 Peak. This powered sub features a built in amplifier for a simply install.
This video applies to Toyota 4Runner models for years 2003, 2004, 2005, 2006, 2007, 2008, and 2009. This video also includes kick panel removal, complete installation for the powered subwoofer / amp, wiring, and testing!
To see an unboxing of this sub, click here:
• Best Powered Sub On Am...
Click here for the radio install video:
• 2003 - 2009 Toyota 4Ru...
Click here for the backup camera install video:
• 2003 - 2009 Toyota 4Ru...
Click here for the front door speaker install video:
• 2003 - 2009 Toyota 4Ru...
Click here for the rear door speaker install video:
• 2003 - 2009 Toyota 4Ru...
If you have any questions, leave a comment below! Be sure to like and subscribe!
Parts used (Amazon Associate Paid Links):
*Rockford Fosgate 12" P300-12: amzn.to/3y5wrlG
*8 Gauge amplifier wiring kit: amzn.to/3iWX7jK
Other Parts Used (Shown in the radio install video) (Amazon Associate Paid Links):
*Sony XAV-AX100 Radio (Discontinued)
--Recommended Radio: amzn.to/3ALE9EH
*Crux SWRTY-61S Stereo Harness adapter (non JBL): amzn.to/3iqHcK7
*Metra 95-8202 Dash Kit: amzn.to/3gNTSJM
*Hosa YRA-154 3.5 mm to RCA Female Cable: amzn.to/3wakBW4
*Toyota USB Flush Mount Adapter: amzn.to/2U02lRm
Disclosure: As an Amazon Associate I earn from qualifying purchases

Пікірлер: 13

@ProvoBeastAudio Жыл бұрын

Parts used linked in the description of the video!

@tivowillieb Ай бұрын

The is one of the most professional stereo install videos I've ever seen, however, I 100% dislike systems that have an amplified subwoofer with the mids and highs from the radio only. The bass is usually way over powering the mids and highs. My goto setup is a 5 channel amp, 4 channels for front and back stock speakers for midrange, and 2 separate high quality tweeters. Midrange can utilize the 4 stock speakers since it's crossed over. The remaining channel will be mono to the sub. All 7 speakers are crossed over from the amp and equalized from the radio. It's very well balanced, hits hard, and sounds awesome with crisp highs.

@calebway5369 Жыл бұрын

Incredible instructions! Absolutely perfect thank you so much it is exactly what i needed!

@tallevandavies Жыл бұрын

Hi! Great video, thank you for putting it together. I'm not sure I want to replace the factory radio and I saw this graphic on your video: "If you didn't have an aftermarket radio, you can simply use a line out converter, or wire these RCA ends to your speaker wire in the 4Runner." Is there anything you can point me to to explain these 2 options? Would love to know more.

@johnford7934 2 ай бұрын

Great videos! I've followed all videos radio, door speakers, and backup camera. Now I'm installing the amp/subwoofer. I've used all of the same products that you have but I have two questions. What did you set the amp settings on and why did you run rca jacks down the passenger side and not the driver side? Thanks for any help you can give me.

@VALtube77 3 ай бұрын

I have same old, old, old... subwoofer: Blaupunkt XLB 300A aka Rockford Forsgate P300 😅

@donp3781 8 ай бұрын

How do you add the unit to a factory radio? Do I need to purchase other hardware?

@ProvoBeastAudio 8 ай бұрын

Technically no, you can cut off the RCA ends and extend those wires via speaker wire and tap into any speaker wire in the vehicle (trim permitting). Alternatively, you can get a line out converter to send signal as well. just a few different factors there. If you send me a message on facebook or instagram, i can point you in the right direction.