I have a 2001 that had the same problem you had. The car had problems starting and when it did start, I was able to pull the key out while it was running. Eventually it wouldn't start at all. I think that because of the worn-out cylinder there was security issues preventing the car from starting. I wasn't looking forward to having to replace the key cylinder. Thanks to your 5-minute fix I don't have to. You saved me a lot of time and money. Thanks man.

Bro I been dealing with this problem for 6 years I have a 05 Impala and I went out and did what you did to yours in 3 mins and my car is cranking right up thanks man you are the best💯🍺🍺

THANK YOU, the wire trick worked… starter is just clicking!

Thank Man! Lol this was a BIG BIG BIG help! I been working on this for about a month and change out alot of stuff and still nothing! Even sent it to the dealership, THEY couldn't figure it out! You the TRUTH! I just ran different numbers. I ran 87 to that fuse. This all depends on where the shortage is at in them numbers. My vehicle was a 2002 Chevrolet impala. But thanks bro

Hey, man, just watched your video. And thanks, you solved my problem. With no extras, LOL.💯👍👍👍

Your supposed to jump Pin 87 & 30 That is the load side. The control side is 85 & 86 there is no 98 on a relay I think you were reading 86 upside down.

Buen vídeo a mí me pasó lo mismo y con ese video lo pude arreglar

Thanks for the info, it was all a great help!!!

It works👍👍

Hey thank you for this video it helped get a friends car running.

Good info. Hopefully this post is still monitored, as I have a question. I have a 2004 Impala that has this issue, but only intermittently. Was yours an intermittent issue or was it dead in the water? Mine did it about 6 months ago and started without further work on the issue after about a half hour. It did it for the second time just yesterday. Again, started after 15 minutes or so. Then, this morning, it did it again. It does have the same symptoms as yours-no crank. I crossed it over at the solenoid, and it cranked but didn't start. I was told that was due to the security, and if I'd had someone holding the key in the crank position at the time I was jumping the solenoid over, that it would have started. At any rate, what are the chances of this being the same "fix" for mine? Any input greatly appreciated.

I had that problem not long after we got our '04 Impala new. Took it to the dealership because it was under warranty. Their mechanics could not figure it out after keeping the car for over a week. They had to call Chevrolet corporate to find out what it might be. They had never run into that problem before. It turned out to be the crankshaft position sensor. Once they replaced it, the car fired right up.

Thans a lot goodfella, it works. Gracias amigo si funciona.

Gonna do this on a 2000 olds alero just put in a new starting and doing the same thing your is. Just wondering could a Seized alternator cause that no crank?

Crank Relay switched out and sure enough, turned on. I still get the security light every once in a while when I’m driving. Is there a fix for it? I don’t think the description is a permanent fix for this. My biggest concern is that my car won’t crank again because of the security light.

So what is the issue here? What would you fix besides running wire?

The green wire fusible link burned on my 2003 Impala LS. The car started perfectly until that happened. What would cause that? I'm thinking the starter or solenoid shorted out for some reason.

Looks like you connected the positive to pin 85. Top left pin front view.

I got a 2004 Impala an wen I got the car it came with no keys. I have the whole ignition switch. Out I'm basically down to wires I was wondering if Yu have a opinion on how to get it to crank ??? Bypass the security?

Hoping you still check this video. Started having the same issue intermittently now it won’t crank at all and I’ve gone through two batteries now drained… I was looking to replace the fuse link that’s connected to that terminal to the left of the fuse box is this the same idea?

I just did it and the car started for the first time in a week but it was the bottom left terminal and I found switched power in the fuse box below the one you have opened. I used the engine devices fuse. Mine is an 04 also but my problem started while I was working on the brakes and they are not pumping up after replacing a rear brake line now that it's running. It's like the master cylinder is not moving fluid. I don't know if the abs system is causing the problem or the master cylinder took a dump. But the engine runs thanks to your trick. I knew there had to be a way to bypass the security but I didn't know where. Any tricks on my brake problem? Thanks for the info, it led me where to work at but just a different terminal.

So you ran that wire for the off position from that 20 amp fuse to the same connector you hsve the other wire connected to on the relay?

My.2008 Chevy Impala is throwing code p0641 says reduce engine power. It only wants to start when it's cold. I couldn't hear the fuel pump kick on at all when I tired the key then when I heard it it started and I could reve it to 2,000 rpm. But earlier it would stall of u gave it gas if we got it started . I have changed crankshaft position sensor oil pressure sensor n also had the reduce engine power come on cuz of bare wire that got fixed to now I'm dealing with this. Originally it was low on oil but now it's saying reduce engine power mode and I can't get the code to clear. Any ideas do you think it's the fuel pump? Plus it's reading code p0449 but I always had the EVAP code on since I bought it and it never caused problems with it running

Hey so I’m having the same issue with my car Currently. I’m a little confused are you saying the issue with the car is that the security system needs to be rewired. That’s why it’s not starting? I have an 05 impala. Same issue

Cuban boy haz otro vídeo explicando lo del cable que pusiste del la caja de fusibles interior del carro hacia la caja de fusibles del motor.

Thank you !!❤

Do leave the wire on or take it off

Hello, just found you video, I have a 2003 chevy venture van no crank no start , replaced the ignition switch cylinder, the stater is good all the relays are good all the fuse are good, the neutral switch is good , on the starter relay I get voltage on pin 85 with the key on that is the positive signal. pin 86 suppose to the negative signal coming from the PCM, the PCM is not sending the negative signal to activate the relay. I apply a negative signal with a power pro and the motor turns but not start. The PCM gets battery voltage and I check one of the map sensor and I get a 5 volts reference, I believe the PVM is ok but I can figure out why is not sending the negative voltage to the starter relay, Also I try to connect the scan tool and is not communicating with the PCM, Do you have any clues. Thank you for your time

Where did you get the small connector wire to hook between the fuses ?!!! I might need that possibly, 2004 chevy Impala acts like it wants to turnover but it just doesn't crank, I've charged the battery, I've changed the starter, also I've put in a new alternator, so I'm thinking it's a fuse problem or something like that Can you help me please

Hey Cuban did all that but is cracking but not starting turning over in account position any though my friend. No not jumping new batterie

Is this fixed still working for you ? Appreciate that you shared this im gonna try this on mine 2002 ls

I have a 2004 impalla doing the same thing. When you used a jumper wire did you just leave the wire in it ( permanently?) It looked like there was no jumping wire in under the fuse/relay at the end if video....if you can reply lmk thank you.

So did you bypass the security? I have a 05 impala and the dealer told me nothing that helps. Just want to get it to crank. Will try this tomorrow!

So I'm trying to diagnose why my 04 won't crank with the key. It does start just fine if I put 12v on the top right pin of the starter relay but not if I jump the top right and lower left. Then I get nothing. Any ideas?

Update 12/22/2022 the car always cranks and starts with no problems. I just posted another video on the same car. kzfaq.info/get/bejne/o9-Km6SbtM6ommg.html

My car will not go in drive I'm in a 2004 Chevy Impala I'm trying to figure out what do I do

I did this but my car dont try to turn over like this one does with the wire it still just clicks i tested the starter they said it was good

What is this wire you are using and where can I get this wire from

I just wanted to ask if you have the same issue where you can pull out the key while the car is running. Thanks.

In the final clip did you lead that wire from the 15A to the back of fuse panel or spliced it with signal wire? Don’t want to fry my relay

I have a question for you. On my 2000 impala, starter is good, battery is good. I checked the holes where the Crank relay goes. On the left, I got both positive working and on the right side only top (negative) hole is working. But the right bottom hole negative is not working. Do you know when the hole gets activate to negative. thanks

Clean all your grounds they put em to paint with a star washer

I have a 2004 Chevy Impala not cranking new starter new spark plugs good battery security light is on

I had same problem and replaced the fuseable link to the left of the box there.

When doing the test, do you leave the key in the on position?

My security light blinks but it’s never given me any issues

❤ 7:14 What up my man I got a 2007 Impala and it does the same thing if I send you my Email will you send me a copy Jerry

Mine won’t even show any signs of battery and the battery’s not dead like it won’t even show anything on the dashboard what could this mean?

I just watched this an did this to my car an it started back up but the next day went back to no crank no start

Did you recently replace a water pump on the vehicle?

Will this work for 2014 impala as well?

What fuse did u use to crank car with 98

So does that mean that the relay is bad?

If this works you are a genius, This security crap caused two tows.

If the security system is activated will the police follow you around like you stole your own car ? I had a faulty security system on a ranger and I got insane surveillance , I would get aircraft just by connecting the battery, and I own the truck free and clear with no lean , weird

My car will crank tho just not start when it's warm it seems.

Where can I get a wire from

La gua gua, dont crank, wont start ???

Dude the video was informative. Your audio sucks

Could I replace the fuse or that's not exactly the issue? Do I have to run a separate wire?