Died suddenly on the road. Flashing m and s lights
Пікірлер: 72
@billb3444 Жыл бұрын
Interior fuse box. Had the same on my NAS 2000 D2. Initially thought it was the CKPS but had only changed it two years before. This drove my nuts for a week or so. Had a job sourcing an second hand interior fuse box and away it went. Old fuse box showed no signs of damage or water intrusion.
@mateibeloiu1144 жыл бұрын
My Symptoms: M and S lights are flashing. The car does start, but sometimes it has trouble getting into gear. When it does get into gear, it does not shift out of 3rd. Fix that worked for me: After reading some of the comments here, I attached a portable jumper to the battery, turned it on and started the car. The flashing M and S lights went away, car immediately shifts into Drive and Reverse and when brought up to highway speeds, it shifts normally. I have an old battery and having the extra juice connected to it at startup took care of my issue. I would've looked at the gear box electric sensor if this would not have solved it.
@peteravery83427 жыл бұрын
put the gear selector in park.... remove the keys and select the car locking button on your key to activate the immobilizer (red flashing light on dash) then unlock the immobilizer as if you were getting into the car... put keys in ignition and start the engine. the two green flashing transmission light will have gone and also the flashing light on the gear selector will be solid again when selected... this fault happens as a safety trip if you try to start the car with the gear selector in the drive position...problem solved until you accidentally do it again like i do quite often lol
@jonathandavey696 жыл бұрын
Peter Avery i
@hardwrk36174 жыл бұрын
I just had the flashing light issue on my 03 Disco. I followed the locking action and the fix worked - thanks for the fix.
@busuttil85 Жыл бұрын
You absolute legend I was flapping when this just happened to me done exactly what you said and boom all fine. Thanks
@timhall97317 жыл бұрын
XYZ switch on gear shift, also called the stop start switch in some manuals.
@mcgillwoodward4986 жыл бұрын
I love those chimes.
@Kamil-w7k3 күн бұрын
Hi, can you write what was the problem. I stucked abroad with exacly the same and can't find solution. In my car the coolant temp. lamp is also on and the car don want to start. Thank you.
@danielh68473 жыл бұрын
That happened to me once and it was because the negative plug to the battery slipped off lol. I was like ah damn another thing I gatta fix. But I plugged it back on the battery and worked fine
@byoungpak84736 жыл бұрын
replace crank shift sensor. I have a 2004 landrover discovery 2 that same problem.
@mickeywalker35356 жыл бұрын
Byoung Pak crank shaft I had same problem as well.
@ehrenfrieditamunuameroro8730 Жыл бұрын
My Discover 2 V8 hazard lights coming on automatically and won’t go off unless battery is disconnected. Engine won’t while hazards are flashing. What could be the problem.
@foreversingle19753 жыл бұрын
I don't understand. Why have it in drive, no car starts in drive.
@gunnarbondank3893 Жыл бұрын
Do you think the alternator is a problem
@wyckedhunter18595 жыл бұрын
2004 d2...doing same what did you find out
@edsonmiranda72635 жыл бұрын
Hi My Disco 2 V8. All of the sudden started Blinking the M and S green lights and there is a considerable loss of power. Can you help? Please
@SuperTraxxasman1235 жыл бұрын
M and S is a transmission fault. The loss of power is caused by the transmission in limp mode. I’ve seen it caused by low voltage caused by a bad battery. Try charging the battery, disconnecting it from the truck, leaving it for 20mins or so, then reconnecting. This will clear the transmission codes. If it doesn’t you are going to have to get the transmission codes read by a Land Rover mechanic, and they should be able to direct you from there.
@edsonmiranda72635 жыл бұрын
Thanks a lot. I will try to sort it out Tonigh. Staring by remove the battery for several minutes and then by charging the battery all the night long. I will come back to you by tomorrow with a feedback wether it has positive results or not. Thanks a lot again for your instructions. Cheers
@edsonmiranda72635 жыл бұрын
I placed a new battery but the problem continues. Took it to a Friend to read the errors and erase. Drove roughly 1 km and the lights came on again.
@edsonmiranda72635 жыл бұрын
Removed gearbox an transfer oils. Were black. Put new oil and running well but sometimes lights come and go.
@17dpetro5 жыл бұрын
DPETRO
@robertolupot63486 ай бұрын
Selector switch not having good contact ,had similar problem
@StarsAtNight Жыл бұрын
Did you figure out what the problem was? Mine is doing th exact same thing.
@carloscruz21578 ай бұрын
Good morning! My discovery 2 td5 had this same problem, and the nanocom does not communicate with the ECU, could anyone help?
@gunnarbondank3893 Жыл бұрын
I had a Land Rover discovery and the battery died on it so I might have need help with that
@thedogancanunver5 жыл бұрын
did you fix the problem ? what for is this problem
@FranciscoRodriguez-tz1uo2 жыл бұрын
Saludos desde puertorico.. Yo tengo el mismo problema con mi discovery 2 2006
@Grigory_9994 ай бұрын
Found the reason??? Why is this so?
@rickycocksedge7942 жыл бұрын
Did you fix the problem and what was it cause mine is doing same right now and I can’t find the problem
@oOAltoOo2 жыл бұрын
tried the xyz switch? kzfaq.info/get/bejne/jriincKTsZmzaZ8.html kzfaq.info/get/bejne/rsqidtCWvpzbdX0.html kzfaq.info/get/bejne/jduGfcxn3Lquhnk.html there's an early and a late type switch on 03-04s I'll be cleaning the contacts out for my missus tomorrow.
@abigorm.9056 Жыл бұрын
First time it happens to me it was fixed by replacing xyz switch Second time it just needed a battery replace (the battery had a history of running out of juice, something to do with voltage) Good luck !
@MatthewDavidAlbritton9 жыл бұрын
Mine did the same thing -- Try replacing the fuel pump relay.
@carlosdavidgrassalevangeli378421 күн бұрын
La mía está igual
@sandycumbrela58892 жыл бұрын
Es la conexión que está detras de la caja dé fusible de afuera
@rayrooney1 Жыл бұрын
I had similar issue with a td5 recently took the black connector to the ecu off and sprayed it with contact cleaner and it started right up. Wasn’t sending the power to the fuel pump relay.
@rickywilliams56504 жыл бұрын
Hey has anyone figure out what's the problem for the dicso 2 when this problem occur..
@86billyjoe6 жыл бұрын
Hey ST, how did you fix this pls? Mine is doing the same thing!
@SuperTraxxasman1236 жыл бұрын
It turned out to be an issue with the connection to the ECUs under the dash. I unplugged them and plugged them in again and it started working normally. On yours, I’d try replacing the crank sensor. Do you have the flashing M and S as well?
@86billyjoe6 жыл бұрын
M+S lights flashing too. I've replaced the crank sensor and its still doing the same. The worst part of it is that it works and then it doesnt so its tough to diagnose. I'll try playing with the ECU's under the dash. you got any pics of them? Mine is a right hand driv. Many thanks for getting back to me!
@robairboctor39495 жыл бұрын
@@86billyjoe guys i am going crazy. My car does that and now it wouldnt start at all. Help?
@charlesbennington57354 жыл бұрын
@@robairboctor3949 same
@robairboctor39494 жыл бұрын
@@charlesbennington5735 my mechanic found out it was a problem with the immobiliser. My car used to stop half way while driving and then never start
@giovanniortiz8928 жыл бұрын
mine is doing the same the only thing different is that my d2 is runing sometimes the m and s lights are flashing than i turn it off and turn it on and it doesnt do it anymore ..
@tylermobraten50818 жыл бұрын
Flashing m & s means gearbox fault. Is your battery staying charged? It can sometimes be caused by low voltage. If it's not voltage, I would have the fault code read by someone with a Land Rover specific scanner (not just a generic OBDII). That would tell you where to go from there.
@sandycumbrela58893 жыл бұрын
El problema es la caja de fusible del motor
@rubenarmenta46333 жыл бұрын
Tu crees? Tengo el mismo problema en una 2003 exactamente igual prende se apaga y despues de un rato fria vuelve aprender y se apaga
@charlesluckyluciano51744 жыл бұрын
hello my truck does the same flash but does not walk more than reverse
@Burner3554 жыл бұрын
If it doesn't work in reverse I'm assuming it's a transmission problem
@gunnarbondank3893 Жыл бұрын
I know what’s wrong with it it’s the alternator
@tylermobraten50818 жыл бұрын
Turned out to be a dodgy connection the ECM.
@nh6024728 жыл бұрын
+Tyler Mobraten What should I be looking for, what do you mean by a dodgy connection? I have replaced every possible culprit for my M+S problem, nothing worked, so I'm starting to believe it is a connection somewhere EMC related, someone also suggested to check the wiring harness, I'm not an expert. Any help is appreciated.
@tylermobraten50818 жыл бұрын
The ECM is behind the passengers side kick plate (black panel under glovebox). It is held against the side of the truck with plastic nuts (10mm IIRC). I would unplug it and inspect the plug and the module for corrosion. You could clean up the contacts with a wire brush and some electrical contact cleaner. I would also do the same with the BCU and the TCM. The TCM is located under the drivers seat, beneath the amplifier for the speakers. I'm not sure where the BCU is. I would also look into your fuseboxes. Sometimes the solder cracks in them due to age, and causes strange issues. You could pull a fuseboxes from a wreck and try changing them just to be sure.
@tylermobraten50818 жыл бұрын
+Nabil Hijjawi What exactly is your truck doing? Is is a no-start similar to this, or just the m and s?
@nh6024728 жыл бұрын
After resetting the M+S for few days in a row, eventually it starts behaving in exactly the same way you car did in the video (will not start), if I unplug the crankshaft position sensor, and plug it back in, the symptoms disappear for one whole week and then M+S eventually start flashing …. Until it won’t start, if I unplug the crankshaft position sensor again, and plug it back in, it goes fine for another week, and so on....
@tylermobraten50818 жыл бұрын
I would take a good hard look at the neutral safety switch. (Also called the WXYZ switch). It doesn't sound like the same issue as this truck, because when the ECM lost connection, nothing would work, and diagnostic tools wouldn't connect. Your issue could also be a bad fusebox. M and S means a transmission fault, so I would put my money on the WXYZ switch.
@faisalal-osaimi38566 жыл бұрын
I need a new battery man...that’s all
@clarencepeyatt46847 жыл бұрын
my 95 Landover stars up runs for while stalls an won't start back up after a while it will start back up it's getting spark an gas what's worng
@Spoons814 жыл бұрын
Ever find out what it was?
@Inanutshell59193 жыл бұрын
Sounds like immobiliser needs bypassing can buy part to do it and plug it straight in , or dabble with wire to bypass it either way bummer of a job but once radio ect out piece of cake
@newholland99046 жыл бұрын
S and m flashing and also d and lose power
@josefelixrodriguez18828 жыл бұрын
replace the battery
@dinghenryst8 жыл бұрын
low battery
@MatthewDavidAlbritton9 жыл бұрын
Mine did the same thing -- Try replacing the fuel pump relay.