2006 Toyota Tacoma Blower Motor and Resistor, Only High Speed Works

Рет қаралды 46,240

Күн бұрын

Blower Motor = amzn.to/35UokLe
Blower Motor Resistor Kit WIth Wiring Harness Pigtail = amzn.to/2Wrw7gE
Your blower motor may lose one or more fan speeds. Typically the low fan speed burns out first as it is the highest amount of resistance. In most cases, you should test or consider replacing the blower motor at the same time as the resistor.
00:00 - Intro
00:51 - Remove Blower Motor
01:10 - Remove Blower Motor Resistor
01:25 - Install New Resistor and Motor
03:10 - (Optional) Replace Old Connector

Пікірлер: 23

@domingodeanda233 3 жыл бұрын

That was pretty damn good, thanks

@montydaniels1054 3 жыл бұрын

I just wanted to browse through KZfaq because I figured that when the blower motor would only work on high that it was the same issues just as it is on most 2004 & up, SUVs, Jeep lines & these Toyota pickups. I've often wondered if it could just be a bad resister but according to all the guys I've talked with, no. It was the type of motor's that the manufacturers all seem to be using. On Jeeps they go out at 135k miles to 160k miles. Now on the Toyota's I've looked at, they're able to go well above the 200k mile mark. I think it's wild since the motors are all the same make/specs that usually run $35-$50 each. Then at local auto part stores, they're 2-3 times the price for the same motors & resisters... Pretty funny if you ask me because I never thought I'd see the day when I could go up to the local Auto Zone I deal with and actually beat their prices about 95% of the time...

@stanleykachuik2589 3 ай бұрын

If it works while wiggling the harness while plugged in. First, Just change the harness and put in a new cabin filter. Then try changing the resistor. And last is blower motor.

@abisismael1343 4 жыл бұрын

Thanks guy !

@Davidjb37721 4 жыл бұрын

Thanks

@jf922 3 жыл бұрын

What are the 4 wires? Yellow with green stripe is ground right? What about blue, white with blue stripe, and white with black stripe?

@andysattazahn275 Жыл бұрын

What is the size bolt for the Blower Motor Resistor? I know the fan is 7/32, are they the same?

@joecarrizales5881 2 жыл бұрын

So I need to change both?

@asaifpathan3618 4 жыл бұрын

We need to replace both resister and motor, why? And just replace resister in above case won't work

@APDTY 4 жыл бұрын

great question. The blower motor is actually the higher wear and tear part of this but in reality with the resistor and motor wear out together. The resistor is actually evidence that the motor may be worm out and this can be tested by performing an amperage draw test to see how many amps the blower is pulling. Most of the time a blower motor will wear out but still spin and seem to work fine, however it is pulling too many amps out of the blower motor and this burns up the resistor and sometimes the wiring. In cases wear the vehicle is over 10 years old or younger with tiger mileage, you are almost always going to replace both parts at the same time. Otherwise you install a new resistor and the new resistor usually fails over and over again until the motor is replaced.

@useruser400 3 жыл бұрын

@@APDTY Fact. But I don’t know why this entire assembly isn’t protected with a fuse. Resistors and wires should not be burning up when the motor draws too much current. Very poor Toyota design.

@mistermeeawwgee7225 3 жыл бұрын

Great video but im cringing at your crimp job. that stuff your crimping is solder and needs to be hit with a heat gun to melt it and make the connection.

@matthewbattenfelder1748 3 жыл бұрын

Big mess

@localforearm1627 3 жыл бұрын

i just tapped my motor and it started working again

@alexmlo1 4 жыл бұрын

i bought and installed a resistor like this and 2 years later I'm having the same problem. Am i going to have to do this everytime it goes out?

@myteli 3 жыл бұрын

strongly recommended to only use toyota original parts

@FogataMexicana 5 ай бұрын

What brand of parts did you use. Apparently reading through the comments the blower motor ends up being the culprit to the entire problem.

@FogataMexicana 5 ай бұрын

What brand of parts did you use. Apparently reading through the comments the blower motor ends up being the culprit to the entire problem.

@truepatriot8751 11 күн бұрын

Toyota upgraded that part now has a square connector. Instructions for matching wiring on KZfaq.

@84yung 2 жыл бұрын

I did this and now its on high on all the settings. 😂 Anyone know what i did wrong? pls let me know.

@anthonyporcarellosr3627 9 ай бұрын

I have a question more than a comment, my A/C works only on hi so I purchased a new resistor, pulled out the old one put in the new one and I get nothing? It doesn't even come on an any speed?? any suggestions as to what the problem is?, I did notice that the connector did have a small burn on it and I have not replaced it yet, do you think that could be the problem as to why the new one doesn't work at all? Believe it or not I have replaced it with 2 different new resistors and gotten the same result....nothing. Any suggestions would be greatly appreciated. thanks

@FogataMexicana 5 ай бұрын

It’s the wiring harness that gets burned usually the white and blue wire is the culprit.

@joecarrizales5881 2 жыл бұрын

So I need to change both?