Find parts at apdty.com/ 00:00 - Intro 00:55 - Remove Fan Shroud 02:28 - Remove Starter 03:48 - Install New Starter 06:56 - Install Fan Shroud
Пікірлер: 31
@faizalbosch6302 Жыл бұрын
Finally someone that doesn't talk all this BS and just go straight to what we need to know
@tudong24463 жыл бұрын
Suggestion: unplug the negative terminal instead of positive. Using a short 8mm socket to push the 2 wire tied down clips out instead of pulling or prying.
@PRod7544 Жыл бұрын
I laughed so hard when you put power back to the car! Almost like the car was like “watch this I’m gonna surprise the hell outta him” haha! Thanks for the informative video! Getting ready to do this myself but now I know to insert the key in the ignition before I hook the battery back up! Lol.
@GigasAhriman Жыл бұрын
BEEP. 😬
@GigasAhriman Жыл бұрын
Tip that helped me was when I was putting in the new starter, tighten the difficult bolt first and then the easy to see bolt
@bojukakt222Ай бұрын
Good camera work though. I hate when mechanics skip everything. I NEED to see everything you do lol ty
@user-rx3xg6xc1p2 жыл бұрын
That would have scared me too. You handled that well, amigo!
@prezaricardo17492 жыл бұрын
Good video..Ready to do mine now. thanks
@julioperalta58192 жыл бұрын
very good video
@jameswhite13192 жыл бұрын
Thanks for sharing
@j.albertofuentes28743 жыл бұрын
Removing the negative terminal will avoid the alarm to go off? And also won’t scared me like it did to you when the freaking alarm went off . 🤔🤔🤔 other than that..... good job
@curtisw.anthony3171 Жыл бұрын
Why did you wait to connect the wires to the starter until it was fully installed? Could you connect them before installing?
@joehyundaitech79613 жыл бұрын
why did you remove the positive instead of the neg terminal on the battery just curious?
@tirsovalls91222 жыл бұрын
Reason being, he correlated the positive terminal on the starter with the positive terminal on the battery, that's my understanding according to what he says towards the beginning of the vid. Apparently tho, according to someone else's comment and what sounds like could be your practice to disconnect the negative to cut of juice, still allowed for the car alarm to go off at end on the reconnect, I just went ahead and disconneted both terminals on the batt after watching this vid which was a definete help with the install.
@user-pv6tt7dc9t4 жыл бұрын
👍
@josephescoto77023 жыл бұрын
Where is the wire top to starter 1 wire go to wer
@Sinofpride5042 жыл бұрын
Bruh I took the 2 14mm and the starter still attached not even loose
@Technllcs2 жыл бұрын
Would this be the same process for an 06 Corolla?
@EdPMur2 жыл бұрын
I think so yes
@tirsovalls91222 жыл бұрын
Same starter fits 03-08 TC, pretty safe to assume so, ultimately tho boils down to where the starter is located in the engine.
@bojukakt222Ай бұрын
I have a 06 too. What's in the video is the same spot mine is too. You're good.
@raysandoval4314 Жыл бұрын
The 14mm are so tight what can I do to take them off?
@J-J-TL10 ай бұрын
Have you tried to loosen it with good o' WD-40?
@Roller762 жыл бұрын
👉🏽Solenoid 👍🏽
@fronesis0110 ай бұрын
I'm from Panama and the Starter of my Corolla, doesnt started yesterday after I ended up my shit at work. One of the worst sensations ever.
@josephescoto77023 жыл бұрын
Toyota Corolla 1998 gts
@billyswafford23952 жыл бұрын
How to make baked beans
@user-cg7jp7jt4v2 ай бұрын
Can this be done without moving fan
@j00ktauАй бұрын
yes but u would need to jack up the front of the car so I can grab the starter from underneath
@user-ex5vu8yn1u9 ай бұрын
Стартер мичубиш 1,8Дизел. 88 година. , 3:24
@jdeast85693 ай бұрын
Why is the starter replacement on the corolla so simple to do as compared to the honda civic? Civic is PITA to do and you have to get under the car. Extremely bad design. Corolla is the way to go. My Next car is Toyota