2008 Ford Focus Rear Wheel Bearing Replacement without press

Рет қаралды 10,566

Жыл бұрын

Disclaimer:
Due to factors beyond the control of Anything Auto, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Anything Auto assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Anything Auto recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Anything Auto, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained.
If an Anything Auto Video has helped you out please consider giving using "Patreon" to help support us. The videos take real time to create and Publish so every dollar spent goes a long way. CLICK HERE:
/ anythingauto
Anything Auto Store: anything-auto.creator-spring.com
Instagram: / anything201. .

Пікірлер: 8

@Distributorr Жыл бұрын

This has been great. I suppose I was lucky enough to find a whole new wheel hub on rock auto with bearing. But the additional information of a new nut and cap was helpful. Thanks for the video!

@AnythingAuto Жыл бұрын

Glad the video helped. Please like and subscribe for more

@johnfry Жыл бұрын

Great video, short and to the point. Thanks for posting

@AnythingAuto Жыл бұрын

Glad the video helped. Please like and subscribe for more

@Paul1958R 6 ай бұрын

The very first piece that you destroyed when you pried it off the drum (@3:08) was the water seal carrier that the rubber bearing seal on the spindle rides on. I see you did not replace it which will allow water/dirt to get into your new bearing. The water seal carrier is easily removed from the drum - without damage - by gently prying with a small flat blade screwdriver _from the inside and underneath_ it - not from the outside like you did.

@AnythingAuto 6 ай бұрын

Yes I did destroy it. It was replaced before installation. It doesn't show it there but if you watch the other side video (maybe posting at a later date) you'll see the replacement of that seal. I realized during editing it wasn't filmed. i hope this video helps. feel free to like and subscribe for more & if you can, please help the channel out by giving a super thanks. Making these videos takes a lot of time, but we do it to save you hundreds. also head down into the description and check out the link for some high quality led bulbs for this and any other vehicle. use my referral for a discount. Add me in Instagram for behind the scenes pics and Stop by my store for some Anything Auto gear.

@btd2516 Жыл бұрын

Why didn't you buy the drum with installed wheel bearing combination? Its only about 20 bucks more and the time savings alone is worth it. I've done three of these and you can do one side in 20 minutes with no cussing.

@AnythingAuto Жыл бұрын

I know right I could not find one whatsoever. Ford could special order them but they wanted a ton of money for it. If you know where to find it shoot me a link and I will put it in the description for everyone else