Thank you so much for this video متشکرم از شما آقای محترم
@realhoffman_32632 жыл бұрын
Seen a lot of bearing vids this looks like my setup thanx
@BugzKiller10 ай бұрын
No Grease on the spindle before install of the bearing and drum?? No Torque wrench to install Nut?
@nathanallendaniel2 жыл бұрын
Any advice on a stubborn dust cap?
@davidferguson461 Жыл бұрын
Tap them out with s hammer. If they break, buy new ones or tap them round again.
@davidferguson461 Жыл бұрын
Do you pack extra grease in the dust cap?
@partsshooter Жыл бұрын
Not on this type, no.
@wardy5271 Жыл бұрын
was you getting a knocking sound before you changed the bearing
@partsshooter Жыл бұрын
Roaring noise
@rudyramonflores7552 Жыл бұрын
You're doing it okay but not the right way always use a little if you need to take those out of the drum take him out you were hitting the bottom that's the reason why you have to use the press could have done without the press if you had just put something on each side please take this, with respect 🔧