2012-2014 TOYOTA Camry oil change 2.5L

No video

2012-2014 TOYOTA Camry oil change 2.5L

Рет қаралды 71,729

8 жыл бұрын

Tools needed:
- 0W20 oil (mobile 1 extend performance)
- Oil filter (04152-YZZA1) "toyota genuine parts"
- Torque wrench (Tekton)
- 14 flute 24mm filter wrench
- 14mm wrench socket for oil drain plug
- Ramps (Rihno ramps)
- Oil drain pan
- Measuring cup
- Gloves
- Funnel
- Paper towel
Things to look out for:
- Accelerate before contacting the ramps then use its momentum to roll up to the top.
- Over tighten oil drain plug and filter cap may damage thread causing difficulty to remove later.
- Over filling oil may allow oil travel into combustion chamber damaging the engine.
Music: Mind Heist
Artist: Hans Zimmer

Пікірлер: 55

@AFreshmanPerspective 6 жыл бұрын

The most epic oil change video I've seen yet. LOL. Nice music and narration.

@houstonwebb3805 3 жыл бұрын

You're amazing keep these coming. Most dramatic oil change ever! Lets go

@simplyservice8543 5 жыл бұрын

OH Man, I wan your garage with nothing else in it! Thanks for the great video.

@njsongwriter 4 жыл бұрын

That was really good and entertaining as well. Additional information would be the torque spec for the drainplug on the oil filter cap. (12.5 N•m or 9 to 10 lb.ft) it's important that it's not put on too tight otherwise the entire oil filter will come off instead of just the drainbolt.

@AllenLo 2 жыл бұрын

Thanks for the info!

@chesson61 4 жыл бұрын

Thanks buddy, you saved me money!

@davids9139 6 жыл бұрын

Nice video. I like that you used a torque wrench, more people should do that. Most people don't use the plastic drain on the filter housing, it's a big waste of time. The 10,000 mile oci is and was pure marketing bs. The maintenance light is documented by Toyota to illuminate every 5,000 miles. The top hole on the dipstick is the "full" mark per Toyota service manual. So which do you trust, the 4.6 qt. spec. or the dipstick? Toyota isn't what they use to be, there are some obvious inconsistencies and cronyism going on.

@tenzackyogi1742 4 жыл бұрын

Do I need a ramp or go over curbside and make it inclined? Savage style.

@jroc01 8 жыл бұрын

good vid and some helpful tips...thanks bro

@AllenLo 8 жыл бұрын

Glad that you find it helpful, thanx

@perezchristian07 7 жыл бұрын

Can you make a video talkjng about the maintenance log that you are keeping up. Interested to know thank you get vid thumbs up

@818750cash 8 жыл бұрын

Great info 👍

@OzKidzFun 7 жыл бұрын

Please make a video on how to change a transmission fluid on Camry 2012 and above.

@jattballer23 7 жыл бұрын

s singh it doesn't have transmission oil jatta

@njsongwriter 4 жыл бұрын

@@jattballer23 Oh course it does. Don't be silly.

@no3mun0z 7 жыл бұрын

Hey got a question. I tried taking the oil filter off turning counterclockwise and it would not turn no matter how hard I pulled the wrench. Should I just try a long bar with a lot of leverage? I'm worried about braking it.

@AllenLo 7 жыл бұрын

Noe Munoz i had difficulty unscreeing it too the first time, because the filter is at an angle, definitely try to use long bar but do it slowly

@njsongwriter 4 жыл бұрын

Everyone who has this system should be prepared for a worse case scenario especially if this is the first time you're doing this. In case of a Stuck Oil Filter Make sure you have the following... 1. The proper Motivx* oil filter cap wrench. Item #MX2320 is for all Toyota/Lexus/Scion engines 2.0 liters and larger using a cartridge style oil filter or item #MX2321 is for all engines smaller than 2.0 liters using a cartridge style filter. 2. A 27 mm ½ inch drive socket 3. A ½ drive breaker bar (18 inches or longer in length. An extension may be needed for some models.) If an oil filter cap seems difficult to remove, only the above items should be used (or equivalent tools). Do not simply use a ⅜ inch drive ratchet or ratchet with extension as these will sometimes result in breakage of the oil filter cap wrench or the oil filter cap. Always make sure the teeth on the wrench are properly engaged with the tabs on the oil filter cap. To prevent reoccurrence of the problem •Make sure new o-rings are properly lubricated before installing. •Use a torque wrench to install the oil filter cap to no more than 18 ft.lbs (25 N•m). Oil filter drainplug = 9 ft.lbs. (12.5 N•m) * If you think the Motivx tools are too expensive at least consider the following... Do not buy an oil filter cap wrench that is made from cast aluminum. Only buy one that is forged. Do not buy one that is strictly a cap wrench that does not have teeth. Do not buy one that claims to fit all models or even all four cylinders. The 2.0 and 2.5 liter four cylinder engines use the same oil filter cap wrenches as the six and eight cylinder engines use. Only the 1.8 and 1.3 liter engines use a different size oil filter cap and oil filter cap wrench. If the oil filter for your four cylinder vehicle comes with one o-ring instead of two then your vehicle takes the same wrench as a Prius or Corolla (unless it's a six cylinder). If your oil filter comes with two o-rings & a service pipe for draing the fikter then your oil filter cap takes the same wrench as the six and eight cylinder engines. Some companies claim their wrench works for all four cylinders but on the 2.5 liter engines that smaller wrench does not engage the teeth on the wrench to the tabs on the oil filter cap. It may work if your oil filter cap is not stuck but it is a poor choice. They are mislead. For those that don't believe this is a problem... kzfaq.info/get/bejne/jdNdibB60LrbZp8.html

@newwavepressure6478 4 жыл бұрын

Is there enough room using ramps to do a trans filter i hav 2014 se thinkin of getting a set ????

@danielmejia1850 7 жыл бұрын

Yeah I had a problem too with the oil filter I turned it to the left and I tried my hardest and it wouldn't come off and it broke. I changed oils before st Cadillac Mazda gmc, never had this problem. Never messed up a car. Idk why this happend to me

@TaijiArban 5 жыл бұрын

Yeah I fear that so I am gonna change the filter cap housing to the metal one. Never want a plastic part that I have to take off and retorque a lot.

@njsongwriter 4 жыл бұрын

@@TaijiArban If people would follow the torque specs I doubt it would be a problem. 18 lb.ft. on the oil filter cap and half that for the drainplug on the oil filter cap.

@njsongwriter 4 жыл бұрын

@sajonkumar9706 3 жыл бұрын

10k or 5k?

@AllenLo 2 жыл бұрын

10k

@1COOL19 3 жыл бұрын

Mpg in city?

@AllenLo 2 жыл бұрын

roughly 24mpg

@ralphreyes2440 7 жыл бұрын

That is pretty cool no need to tell them the code or something? Thanks

@AllenLo 7 жыл бұрын

Ralph Reyes rihnos ramp

@ralphreyes2440 7 жыл бұрын

What it's call if I go to walmart? thanks again

@gushernandez25 5 жыл бұрын

Where do you buy oil filter wrench and how much?

@njsongwriter 4 жыл бұрын

Best wrench is the Motivx MX2320 for Toyota built engines that are 2.0 liters or bigger. It has the very best reviews. www.amazon.com/Motivx-Tools-Toyota-Filter-Engines/dp/B00XTAGHU0/ref=sr_1_2?dchild=1&keywords=Motivx+2320&qid=1591275576&sr=8-2