This is the procedure to for the engine oil and oil filter for the 2012 - 2017 Camry with the 2.5L engine. 🛠 LINKS TO SOME OF THE PRODUCTS & TOOLS USED 🛠 Filter Wrench: www.amazon.com/Removal-Compat... 🚗 OEM Eangg
Пікірлер: 30
@cgrscott25 күн бұрын
Thanks for the walk through. One KZfaq mechanic yanked the entire filter housing off without draining the oil filter housing first. It created quite a mess. Glad you showed us how to remove the filter the way the Toyota engineers intended.
@OEMEangg25 күн бұрын
Thanks. I try to show the proper procedures with no shortcuts.
@dennyu6674 Жыл бұрын
Most thorough and complete video that I have found. Thank you!
@OEMEangg Жыл бұрын
I try to show every single step. Glad to you found it useful.
@mrm8293 Жыл бұрын
You are detailed enough to make sure not to forget anything. I have the same car. Thanks
@OEMEangg Жыл бұрын
Thanks, I try.
@Mark-gx8iq Жыл бұрын
Great instruction's very clear
@MrDigit885 Жыл бұрын
Great explanation
@sweathe3819 Жыл бұрын
Thanks!!!! Very good video
@715028510 ай бұрын
Sir. You did a wrong. NEVER check engine oil level while the engine is running...always check engine oil with the engine OFF for at least a few minutes...why? Because you want to wait til all the engine oil drained to the bottom of the engine pan oil...
@jimsibley16519 ай бұрын
Pretty good video, until almost the end. Hope you don't mind some constructive criticism: the the oil capacity on this engine is 4.6 quarts. Most if not all oil jugs have quart markings, right? Not too hard to get close to 4.6 qts without needing to check the dipstick. But if you do check the oil level via the dipstick, you need to do that with the engine off for a few minutes so all the oil that's been pumped throughout the engine when it's running can drain back down to the pan. As it is, checking it with the engine running gave you a lower-than-actual reading and led to you overfilling it by that 0.4 of a quart. (It's trans fluid that you want the engine running to get an accurate level reading.)
@OEMEangg9 ай бұрын
Comments and criticism are always welcome. Someone else had mention that the engine was should be off when checking the oil level. The engine was off. Your other comments were on point. Thanks.
@lovelee8260 Жыл бұрын
Thank you
@jlb62623 ай бұрын
Check the toyota manual first, for the correct amount of oil . When you check oil when engine is cold it should be between full and 1 qt low. Not full. Reason being oil will expand when hot. So check it after engine is warmed up to operating temp. Turn off engine, The oil should be at the full mark then.
@k0yw79 Жыл бұрын
thanks
@cabdriveruk19 күн бұрын
A Toyota technician told me not to remove the bottom cover he said prodding around with those plastic drain tubes could damage the pressure relief valve.
@OEMEangg19 күн бұрын
The procedure is from Toyota. But the technician does make a good point.
@edwardinvegas2 жыл бұрын
Good man you use a new crush washer... I put in comments for other video creators telling me that it doesn't matter. I always tell them to refer to their vehicle manual you can do as you please sure.... I own a 07' Honda Civic Si and my manual says to replace it, not keep re-using it...
@OEMEangg2 жыл бұрын
LOL. I have a bag full of new crush washers.
@njsongwriter2 жыл бұрын
I think your oil capacity is something like 4.7 quarts. You shouldn't overfill it. To get an accurate reading the oil should be at operating temperature. If you fill it to the full mark with cool oil then when it reaches operating temperature it will be overfull. It's good that you provided torque specs. Would have been a bit better to actually used a torque wrench but you seem to have a feel for how tight it should be. Thumbs up.
@njsongwriter2 жыл бұрын
Actually I believe the 2.5 engine first appeared in the 2009 Camry.
@DuckMcDuckinson Жыл бұрын
2010
@njsongwriter Жыл бұрын
@@DuckMcDuckinson You are correct... 2010 was the first year for a 4 cylinder Camry. 2009 was the first year for a 4 cylinder RAV4.
@aperson1181 Жыл бұрын
do you have links for tools?
@OEMEangg Жыл бұрын
Are you refering to this filter wrench? Filter Wrench: www.amazon.com/Removal-Compatible-Engines-Cartridge-Housings/dp/B09J2CDM1T?crid=2QNFUBSNOJ8I8&keywords=toyota%2Bfilter%2Bwrench&qid=1653970780&sprefix=toyota%2Bfil%2Caps%2C152&sr=8-1-spons&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzTkg4TlM0RTE4VFVPJmVuY3J5cHRlZElkPUEwMjMwMTcwMkM3WlpENElEM042VSZlbmNyeXB0ZWRBZElkPUEwNDg3Nzg0VU4yUFlPQllJVTVKJndpZGdldE5hbWU9c3BfYXRmJmFjdGlvbj1jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ&th=1&linkCode=ll1&tag=oemeangg-20&linkId=5f60634108a8b4d23bad6c668f89595e&language=en_US&ref_=as_li_ss_tl
@aperson1181 Жыл бұрын
4 slots or 6 slots oil tool?
@OEMEangg Жыл бұрын
I don't recall the number of slots. You can get it on Amazon. Filter Wrench: www.amazon.com/Removal-Compatible-Engines-Cartridge-Housings/dp/B09J2CDM1T?crid=2QNFUBSNOJ8I8&keywords=toyota%2Bfilter%2Bwrench&qid=1653970780&sprefix=toyota%2Bfil%2Caps%2C152&sr=8-1-spons&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzTkg4TlM0RTE4VFVPJmVuY3J5cHRlZElkPUEwMjMwMTcwMkM3WlpENElEM042VSZlbmNyeXB0ZWRBZElkPUEwNDg3Nzg0VU4yUFlPQllJVTVKJndpZGdldE5hbWU9c3BfYXRmJmFjdGlvbj1jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ&th=1&linkCode=ll1&tag=oemeangg-20&linkId=5f60634108a8b4d23bad6c668f89595e&language=en_US&ref_=as_li_ss_tl
@TheFraryFamilyАй бұрын
4 or 6 will work for the Camry, but he is using a 6, which is more universal for Toyotas.
@josesoares5703 Жыл бұрын
J Ujjain j Khloe ķ
@matt4398 Жыл бұрын
You warmed oil for 10 seconds? Try driving for 20 minutes next time, then wait atleast 5min after shutting off before checking