2015 Nissan Rogue Transfer Case Removal and Replacement. Axle stuck no big deal!!

Рет қаралды 14,382

Күн бұрын

2015 Nissan Rouge need a transfer case so I removed the old one and put in a new one!! The axle carrier bearing would not come out. No big deal. Watch to see what I did. Up close shots of driveshaft bolts and exhaust hanger toward the end. I hope you enjoy and thanks for watching!!!

Пікірлер: 54

@Rac19802000 Жыл бұрын

Man brother, your video saved me alot of money!!! The transfer case was pretty simple with the tips in your video!!! Thank you!!!

@doingstuffwithdylan4367 Жыл бұрын

Thanks for taking the time to comment! That is why I make videos! Thanks again glad it was helpful!

@PeterTeehan Жыл бұрын

I can fix PC's and build PCs - But terrible when it comes to vehicles lol - I have 2014 Nissan Rogue and my transfer case needs to be replaced. So, I had no clue where it went and or what it does for the vehicle. Thankfully, my buddy is a solid mechanic in our town, and he is letting me do payments on part and labor. Great Video!

@doingstuffwithdylan4367 Жыл бұрын

Thanks I’m glad you got it handled thanks for the comment!

@thenakedrepairman7218 2 жыл бұрын

How about a bright light so we can see better.

@doingstuffwithdylan4367 2 жыл бұрын

I have recently upgraded my lightening! Thanks for the tip and watching!

@sylvainmartin73 3 жыл бұрын

Well, glad I saw you do this. Just replaced the exhaust yesterday on my 2008 rogue awd and noticed some leakage and play where the shaft enters the transfer case. The prospect of dealing with these craptastic fasteners is not appealing at all. I was hoping it might just be replacing the seal but now I'm thinking the bearing would need to be replaced too which I'm sure requires pulling the whole thing out, disassembly, pulling and pressing in a new bearing.

@doingstuffwithdylan4367 3 жыл бұрын

We Just replace the transfer case.

@Rac19802000 Жыл бұрын

I found used transfer case for 150 just replace it!!!

@shenrajcooar9086 Жыл бұрын

@@Rac19802000 where'd you get a transfer case? Wife's 2014 Rogue went to the dealer and they said hers is leaking. Quote about 3500 parts and labor

@ashramdhan1582 2 жыл бұрын

Hey I need to put the oxygen sensor bracket back forgot where I removed it from can you tell me plz?

@doingstuffwithdylan4367 2 жыл бұрын

Probably near the o2 sensor it’s been a while. Sorry thanks for watching and the comment

@RyanFixesCars 9 ай бұрын

Are these transfer case input shafts held in by a snap ring? I have one in the shop with a broken input shaft. The broken piece is stuck in the trans 😅

@doingstuffwithdylan4367 9 ай бұрын

Yes but the carrier is often seized.

@mariemoore2255 11 ай бұрын

Is this the same set up process removal transfer case for a 2017 Nissan Rogue AWD 2.5L?

@doingstuffwithdylan4367 11 ай бұрын

Probably similar just got a look and see

@victorcail5769 2 жыл бұрын

how to find and replace an awd control module and coupler on a 2018 nissan rogue

@doingstuffwithdylan4367 2 жыл бұрын

Not sure man. Good luck!

@aif681 3 жыл бұрын

so how many hours of labor did this take? I have a 2009 Murano that's been sitting in my driveway for a very long time. It has a destroyed transfercase.

@doingstuffwithdylan4367 3 жыл бұрын

Looks like 4 hours or so. A guess but probably pretty close. Thanks for watching and the comment!

@renof2505 2 жыл бұрын

@@doingstuffwithdylan4367 It would help a ton if you had more light on it. Cannot really see what you are doing. I have a 2012 that seems to be leaking trans fluid into the transfer case. Do these transfer cases fail a lot? ~120k, should I just replace the transfer case while I am at it?

@doingstuffwithdylan4367 2 жыл бұрын

@@renof2505 These transfer cases don’t fail very often. If you’re trans mission fluid is leaking into the transfer sounds like the seals bad. We do transmissions on these a lot more than we do transfer cases. Thanks for the comment I hope I was helpful. And I have since upgraded my lighting. thank you for the suggestion

@chadbrailer643 3 жыл бұрын

This must be a rogue select.. I dident have a ptu shaft that went into the trans.

@doingstuffwithdylan4367 3 жыл бұрын

That’s good! Easier that way! Thanks for watching

@321ssteeeeeve 2 жыл бұрын

Yeah, I have to replace my wife's 2017 rogue TC. Dealer wanted $5k lol ($3K pre biden). Now I have to find a part, service manual, replacement parts, and book time on a lift.

@doingstuffwithdylan4367 2 жыл бұрын

Good luck. Atleast it’s newer. I find Nissans pretty easy to work on anyways! Hope all goes well and this video is helpful! Thanks for watching and the comment!

@unkldamo Жыл бұрын

Thank you sir! Now I just need get a lift... 😩 Or a pit. 😫

@doingstuffwithdylan4367 Жыл бұрын

Or a guy. With a place.

@saybay7029 Жыл бұрын

What was wrong with it? I have a 18’ I think that has a T-Case going out. It has a noise almost like a baseball card in a spoke wheel, very noticeable in town driving. Front wheel bearings and CV shafts were replaced before I got it

@doingstuffwithdylan4367 Жыл бұрын

Honestly I’m not quite sure. I’m just the r and r guy on this job. These trannies go bad a lot. Just take it some where you trust and have them check it out. Thanks for the comment!

@jorgeurrutia3802 6 ай бұрын

Bulllst. I. Just. See. A. Crazy. Fellas. Work. Light. No Close up. No. Working like . crazy. Yesssssssss😂😂😂😂😂

@doingstuffwithdylan4367 6 ай бұрын

Sorry I’ve got better lights now and explain every thing better. Thanks for the feedback.

@kennethbutler8271 2 жыл бұрын

It's a good thing he has a lift and air equipment lets give it a try on jack stands with only hand tools!

@doingstuffwithdylan4367 2 жыл бұрын

That sounds awful thanks for commenting and thanks for watching

@melissahuff8483 9 ай бұрын

Can't see anything 😢

@doingstuffwithdylan4367 9 ай бұрын

Sorry I have since upgraded my lighting.

@das18316 9 ай бұрын

Great information except it was so dark and basically only 1 angle so it was really not worth watching for those that kinda need to see what is actually going on... Thx

@doingstuffwithdylan4367 9 ай бұрын

Sorry, I’ve since I upgraded my lighting

@user-gr5kj2tf9k 11 ай бұрын

Would be better if you could improve your lighting. Can't see anything.

@doingstuffwithdylan4367 11 ай бұрын

Since upgraded. Thanks for the feedback

@jorgeurrutia3802 6 ай бұрын

No. Details No light Fast as hell Wtf 😂😂😂😂😂

@doingstuffwithdylan4367 6 ай бұрын

Sorry have since upgraded lightening and explain everything better. Thanks for the feedback

@jorgeurrutia3802 6 ай бұрын

Jaaaaa. Can't c. Sth

@doingstuffwithdylan4367 6 ай бұрын

Soory

@madmikescustomDaily 7 ай бұрын

Yo, yo from one fella Mechanic to another I really appreciate your videos Wow, you did a wonderful job. You could use a lot more lighting on the bottom of your vehicle throughout the duration of your video but other than that it was awesome video. It helped me understand the axle process and taking the passenger lower ball joint on the front wheel off. Thank you so much. @madmikescustomdaily

@doingstuffwithdylan4367 7 ай бұрын

Thanks for taking the time to comment man I really appreciate it. That’s literally why I make these videos. I have since I upgraded the lighting thank you for the constructive criticism.