2017 - 2023 Ford 6.7 PowerStroke S&B Cold Side Intercooler Pipe Install

Рет қаралды 6,939

Күн бұрын

S&B Cold Side Intercooler Pipe Kit - sbfilters.com/products/ford-p...
ARods Channel - / @powerstroketechtalkwarod
▶︎ Subscribe to my Channel- bit.ly/29zfZ2k
▶︎ Facebook- / moostang09
▶︎ Instagram- / moostang09
▶︎ Twitch- www.twitch.com/moostang09
Business Inquiries-seanshortmedia@gmail.com
F250 Truck Mods
Leveling Kit - amzn.to/2QiMtqe
Tailgate Shock - amzn.to/2YnlSbc
Method Race Wheels - amzn.to/2EcW3nA
Nitto Tires - amzn.to/2Uuc7H1
S&B Cold Air Intake - amzn.to/2K3kuHP
Husky Floor Mats - amzn.to/2UqZ1ua
Bullet Antenna - amzn.to/2QHk78pBuiltRight Industries
Rear Seat Release - amzn.to/2BF6TzK
K&N Cabin Air Filter - amzn.to/312BYbH
Fuel Filter - amzn.to/2MOIddn
Above Links are Amazon Affiliate Links
#f250 #S&B #ford

Пікірлер: 29

@donrnels Ай бұрын

This will be my second intercooler pipe. The first was under warranty, now this one is on me. I went with S&B. Both stock ones failed in the same place.

@stevem6711 Жыл бұрын

Nice job. I'm still amazed Ford hasn't updated both this hose and the upper radiator hose, which needs an internal spring to keep it from collapsing.

@lawrencevaliquette 6 ай бұрын

Thanks for the video! Going through this now with my f350 and it’s super helpful.

@kvboyd Жыл бұрын

Upper radiator hose is compressed because the reservoir cap is not working properly creating a negative vacuum when truck is off. Replace the cap and problem is fixed.

@julianvelazquez804 9 ай бұрын

Hey great video! I just installed mine on a 19 f250. I had a small clearance on the front of the intercooler pipe (aluminum side) about the thickness of a quarter. Couldn’t tell on the video if this was normal or not? It did snap in though.

@wlffabrication7196 Жыл бұрын

Anything down stream that can get messed up by making the pipe the non failure point?

@klippelck 2 ай бұрын

Hi are you going to add the hot side from s&b

@Bemer12 Жыл бұрын

Did your check engine light take a while to turn off? Just had the same issue with my truck, installed new pipe and check engine light is still on. Definitely installed right, no leaks, building proper boost and fuel mileage back to normal. Thinking may have to replace the air charge temp sensor.

@The1manchu 4 ай бұрын

What was the fix??

@Bemer12 4 ай бұрын

@@The1manchu Check engine light went off after about a day or so, everything’s been all good since. Did not have to change the sensor, I did take it out and cleaned it up but light stayed on for a little while longer.

@alexperez6510 Жыл бұрын

Hey buddy can you recommend a good diesel mechanic in utha area ?

@ck3561 2 ай бұрын

Any issues with leaks or anything positive to report?

@markmallory185 Жыл бұрын

nice job - off question when changing fuel filter 2017 f250 always getting 2-4 gallons before its stops dripping this can't be normal.

@tylerhebert9117 Жыл бұрын

yeah I don’t get nearly that much whenever I do mine

@wlffabrication7196 Жыл бұрын

Do it when the tank is almost empty

@markmallory185 Жыл бұрын

@@wlffabrication7196 yep - that's what I'm doing next time for sure...this has been the best truck I have owned

@jonathanschaffer3727 Жыл бұрын

did you ever get the emissions on tuning working correctly

@moostang09 Жыл бұрын

Yes sir! Just had to go a few miles to let everything readjust from the tune then it worked out great.

@blvckgoku 10 ай бұрын

When it calls for oiling the pieces, I didn’t have any oil on me when I replaced it. And I installed it as is. Will that cause it to fail ?

@ck3561 2 ай бұрын

I know you posted 7 months ago but did you have any issues? I installed mine today and honestly I used a little oil from inside the old pipe. The install was straightforward but it was a tight fit but it finally clicked on.

@blvckgoku 2 ай бұрын

@@ck3561so far zero issues! It’s most likely fine now

@ck3561 2 ай бұрын

Thanks, honestly I just don’t want to pull the dam thing off again. Originally when installing I redid it twice just because I didn’t like how it felt clicking on. It sounds like everyone has the same issue. I just didn’t want to put oil all over it. The OEM didn’t have any oil dumped on it just to fit. 👍🏻

@eduardoauceda5135 Жыл бұрын

what’s the first tool you used called?

@moostang09 Жыл бұрын

Milwaukee M12 Cordless Ratchet. amzn.to/3XKvDA7

@livestrib3752 Жыл бұрын

I have a question! Mustang content!? 😎

@robweezy Жыл бұрын

Where’s the mustang?

@darren6790 Жыл бұрын

What a bad design by ford. A truck this new should not have these problems.

@larryphillips4164 15 күн бұрын

Don’t buy the K&N cold charge pipe kit, it’s bs. They trying to save money by not making the little rubber elbow piece too short by 1/2” and the metal clamps are 1/2” too short as well. Fucking hell cmon K&N. I’ll give you $5 more dollars to not make this shit a struggle fest!!!