2017 and up Aprilia Tuono 1100 V4 EVAP Canister Removal Mod.

No video

2017 and up Aprilia Tuono 1100 V4 EVAP Canister Removal Mod.

Рет қаралды 9,983

4 жыл бұрын

In this video I will show you how to perform the EVAP canister removal mod on a 2018 Aprilia Tuono 1100 V4 Factory. (works for 2017 and up)
Hope the video helps, and Thanks For Watching!

Пікірлер: 27

@xxWtChocolatexx 4 жыл бұрын

After I did a pipe and computer I did this and removed the flapper valve motor and my bike rarely gets above 200 degrees. I'm sure a better flowing exhaust had some part in the temp drop but there is so much more free space on both sides.

@Onedown5ups 7 ай бұрын

About to do this and appreciate the video!!! My issue is my bike doesn’t like to start after about 30min or so of riding and then I go to fill up and then it starts acting all stupid on me and doesn’t like to start back up. This will hopefully make all the annoyance disappear.

@stevenreeves4766 Жыл бұрын

You can pull that hose right out of the air box and just seal it off. And why do you need to remove the pressure release valve?

@darrylbailey3097 3 жыл бұрын

Great video!! I would like to ask at 12:30, how did you remove the original clamp from the hose on the right to put the new clamp on there?

@FireTwo 4 жыл бұрын

To remove the two hose clamps the tool is just a click clack pliers cheap on Amazon ext

@techtube3831 4 жыл бұрын

Thanks, good info. Read about it being so expensive from Aprilia on the forums.

@Gouch12345 2 жыл бұрын

Not much point doing this and leaving in the holder for the cannister, throw it in the bin and use the spacer from the spare bolt of the cannister mount (bottom one) with the long fairing holder (top one) to mimic the same length it was. Then recable tie all the messy wiring up away from the radiator

@xxDemonRider 3 жыл бұрын

Did this on my 18' factory and noticed that after the bike has been sitting there is oil that comes out the hose that originally had the valve. I did the same thing as you and used a hose connector and routed it to the right side by the other hose that dangles to the bottom. Has yours done this, do you know why it's dropping some oil? Could it just be old carbon buildup?

@xxDemonRider 3 жыл бұрын

Nevermind, I found that it's just gas after a fillup.

@AlexandreBlondin 3 жыл бұрын

Thanks for your video. After a few months, do you notice more gas smell in your garage? That's what I'm concerned about...

@techtube3831 3 жыл бұрын

You're very welcome. I haven't noticed any gas smell since I've done it. Thanks for watching!

@stevenreeves4766 Жыл бұрын

Oh my god, it us so easy to pull those clamps off took me 2 minumarbles less.

@spericas 2 жыл бұрын

What is the reason for removing the valve on the hose from the tank to the canister?

@techtube3831 2 жыл бұрын

I heard that the valve can possibly stick and cause back pressure. That's why I removed it. Thanks for watching!

@andyro2237 4 жыл бұрын

Does this mod compromises fuel mileage??

@techtube3831 4 жыл бұрын

I've seen nothing mentioned about the effect (if any) on gas mileage. I scoured the AF1 Aprilla forums before doing this, the thing most widely mentioned, other than the main reason for doing it in the first place (relieving pressure buildup in the fuel tank) was the possibility of the bike running somewhat cooler. Thanks for watching!

@kevinmill7965 3 жыл бұрын

Do u get warning light on dash once gone

@stevenreeves4766 Жыл бұрын

No, this is not related to any sensors.

@vxlgsi 4 жыл бұрын

Good vid but can you explain why it makes the bike run cooler when removed?

@techtube3831 4 жыл бұрын

Thank you. From what I've seen, most people are contributing it to increased airflow in and around the area of the canister. I've only had the bike out for a couple of short rides since this vid, but I will report back when I have a chance to truly test the theory. Thanks for watching!

@FireTwo 4 жыл бұрын

TechTube fan is more affective at removing heat away from rad.

@primedirective00 3 жыл бұрын

All the EVAP canister does is vent and store the gas tank vapors in activated charcoal which otherwise would cause smog and make the bike fail emissions tests. When the engine is drawing enough vacuum the canister then recirculates the vapors back into the intake but it's nowhere near enough additional fuel to enrich the air fuel mix to the point where the bike would run cooler. It also won't change how the bike runs at all... but it is possible to throw a code on some vehicles. If you don't know what you're doing then you probably shouldn't be doing it lol

@vxlgsi 3 жыл бұрын

The temp is controlled by a thermostat

@SaddamPoopStain 3 жыл бұрын

@@primedirective00 I deleted mine on my old fz09 because it wouldn't start when sitting out on a hot day. The delete solved my problem. Still have it on my v4 though, have not had that same issue.