Thank you a year later your still helping people like me. I did not know how to proceed when confronted with this electronic brake cylinder. Thank you.. 😅 I did exactly as you said and whala it worked!!

Simply brilliant. I certainly do that no problem. Thank you for this short and objective video. Right on point. The dealer wanted to bill me $400 for a brake job. The pads are only $40 at autozone.

Did this using a 9 volt battery last weekend on a 2020 Santa Fe without issues. It’s sad that Hyundai doesn’t have a brake service mode in the dashboard menu like other makes do. It’s all a money grab as they want you to pay the dealership service department or purchase a scan tool. Thank you for this video! It saved me a lot of $$$

Thanks for posting this! I was removing the motor from the caliper and spinning the epb out with a 5mm allen, this is way easier and cheaper than a $6000 scan tool!

Thanks for posting. This came in clutch today. I ended up using a 9vdc adapter with a drill bit in the center negative. Worked perfect!!!

Thank you for the tip. I spent some time trying to figure this out. Much appreciated

Thank you so much sir!! If it wasn’t for this video I would’ve been screwed, I used a ryobi battery and it worked perfectly I appreciate this video so much!!!

9 volt battery worked where the car battery charger did not work!! Felt much safer this way too!! And instead of the clamp, there is a cheap special tool for the caliper you can use with an old brake pad in front of it to push the caliper piston back in without damaging it!! I see people using screwdrivers while the caliper is still connected to push the piston back in and I think that is crazy and could mess up the caliper!! Thanks for the video, it led me in the right direction and saved me money!!

I used this method with a 9v battery. Worked perfectly! I have the same exact car. 2018 sonata limited 2.0t lakeside blue

Awesome, worked just like you said, I didn't have alligator clips, so I used a wire with a decent gauge, thank you so much. I didn't know what to do, never seen that before

This worked like a charm, thank you very much!

This video was a life saver 🙌🏽🙌🏽🙌🏽🙌🏽

Thank you for the info , greatly appreciated

Thanks for the tip. I bought rotors and ceramic pads from Rock Auto. I hope they fit. 😮

Very helpful video thanks a lot

Your the best. Thank-you

Simple and unique job

Thanks, plan works!

Thank you!!!!!!!!!!!!!!

Thank you! Great help

can you tell me where i can get Parking Brake Actuator

Thank you so much 👍

Thank you!

OMG, thank you!

THANK YOU!!!!

Is it ok to hook it up straight to the car battery or should a charger be used? Sorry for the dumb question!

can this be done with a 24v battery charger or, a 9v battery charger?

Did you spin the electric motor back out or just turn the parking brake on?

Maybe i got lucky but i used the cube on a 3/8 ratchet and turned the piston in by hand.

Is it the retraction thing on both sides ? I guess that is the auto hill hold (and the emergency brake) ? what a pain in the ass

Just unbolt the motor from the caliper, and spin the splined gear with a T40

Do you have to retract the electric emergency brake even if the brakes are not set?

There is in fact an easier way to do this lmao, which happens to be the way intended by the manufacturer