LuSh x NinJaZz I’ll bet he works at 7-11 during the day

Its a turkish accent

🤣🤣🤣🤣 loool

🙂🤣🤣🤣

Yes … Dank You Veddy Veddy much

It does not mean that any time you use it, your device will be affected. It can be harmful when you listen music very loudly. In normal mode, as explained in the video, the limiter is active and it does not let the speaker to be defectively loud. But in low frequency mode, the limiter is not active and at some level there is probability that your speaker can be harmed. It is like a circuit breaker in electricity. I don't prefer to take this risk and I just want to warn JBL Xtreme users. Besides its very important side effects, some youtubers advice people to use it in low frequency mode without any warning. That's why I wanted people to learn this risk.

Wait how does low frequentie mode work? I tested it and their was litterly almost no bass

SnukkieBoy it just gets louder. It works best at louder levels. And outside it sounds best. Couse inside bass is nicee

LFM nothing do

@@luukdebeijer5062 play at max volume and you'll notice the difference.

Hard reset your JBL Xtreme by below video, also in your cell phone's Bluetooth connection settings, remove (forget) JBL Xtreme 2 connection, close and re-open your cell phone, than try to re-connect your xtreme 2 to your cell phone and check it whether it works or not. To hard reset watch below video: kzfaq.info/get/bejne/oKl-o8Sny9vDeJc.html

This is a very good bluetooth speaker. It won't create any problems for you in the near future as long as you good take care of it. I advice you to: 1-Not to use it in low frequency mode. 2-For its battery life, don't keep this speaker attached to electric with its charger. Charge it, than unplug it from the charger, use it until you get the red light on the battery indicator 3-Do not apply any changes depending on youtubers advice unless you are 100% sure. There are many videos on the internet that cause infollution. 4-Do not listen the music with very high capacity voice (95% or above) all the time.

I have this 1 and a half years. I listen to music with a lot of bass. (rap or trap). And the speaker is exactly like when i first used it. The bass is greate and remains the same. The volume is the same too. And the battery life is greate because i use it for 3 days and then it shows the red dot(low battery). It is greate but i used low freq only 10 times. But i use a bass boost app that makes the bass 5 times louder. Thats not good for the speaker i think but i like it(and it still is like a new one). Also yesterday i got outside with this and started rainning. It was wet but still ok. Remember it is Rain proof but you can't put it on water. (I AM TALKING ABOUT XTREME 1)

No man always use bass mode and play it a loud as possible

Merhaba gerek bu videoda gerekse de aşağıda linkini attığım videoda JBL Xtreme 2 ile alakalı (bu ayarlar diğer bir çok bluetooth hoparlörde de çalışır) pek yaygın olarak bilinmeyen özellikleri anlatıyorum. Bunlar: 1-Low Frequency Mode (bluetooth tuşu ile ses düşürme tuşuna 10 saniye bastığınızda low frequency mod aktif oluyor): Bu modu insanlar kullanıyor ama tavsiye ettiğim bir özellik değil. Bu modda bluetooth hoparlörün daha fazla ses çıkartması için zorlanması söz konusu. Bir nevi hoparlörlerin zarar görmemesi için koyulan sigorta bypas ediliyor. Uzun süre bu modda yüksek sesle kullanırsanız hoparlörünüz zarar görebilir. 2-Soft Reset (basit reset): Bluetooth ve ses arttırma tuşuna 10 saniye basınca aktif olur. Low frequency moddan çıkar ve hoparlörü kapatır. 3-Hoparlörde yüklü yazılımın versiyonunu öğrenmek: Ses düşürme tuşu ile JBL bağlantı tuşuna aynı anda 10 saniye bastığınızda cihaz size yüklü versiyonu sesli olarak söylüyor. Aşağıda linkini verdiğim videoda ise kısaca 2 tane daha özellik anlatılıyor: kzfaq.info/get/bejne/oKl-o8Sny9vDeJc.html 1-Hard Reset veya full reset de denilebilir (ses arttırma tuşuna ve oynat (play) tuşuna aynı anda 4 saniye basıldığında olur): Bu yapıldığında cihazın ayarları tamamen sıfırlanıyor. Tanımladığınız ve bağlantı yaptığınız tüm cihazlar hoparlörün hafızasından siliniyor. Ayrıca tekrar hoparlörün telefonla eşleştirilmesini anlatıyorum 2-Low frequency moddan çıkılıp çıkılmadığından emin olmak için hard reset yapılması gerektiğini belirtiyorum. Herhangi bir sorunuz olursa yardımcı olmaya çalışırım.

TechAbet Solutions teşekkür ederim videoların her ikisini de izlemiştim. Ancak İngilizcem olmadığı için, çevirilerdende tam olarak anlayamadığım için detaylarını yazarak öğrenmek istedim. Aslında merak ettiğim hoparlörün sesini daha da yükseltebilmek için ne yapmak gerektiğini öğrenmekti. Sanırım bu sadece low frequency özelliğini açarak oluyor. Başka bir yöntemle yani zarar vermeyecek bir yöntemle sesini yükseltmemiz mümkün mü?

Sander if you have youre speaker on normal. You hear a dun dun sound when u max the volume out. Than it is in normal mode. But if u hear no dun dun than it is most likely in lfm

If you are not sure about the mode, I advice you to hard reset it. kzfaq.info/get/bejne/oKl-o8Sny9vDeJc.html

Just turn it off then back on

@@TechAbetSolutions No need, restarting is more than enough. People make such dumb mistakes and I can't bear reading them.

@@proxyhx2075 so how do i know what mode am i in

It is highly recommended that it is better to use the latest firmware everytime for every devices. You can update your firmware through your cellphone. Latest firmwares improve the performance of the item and fix some bugs.

Just reset it and everything will be back to normal

Same 2 Me jbl xtreem 2 Before working 🙂🙂🙂🙂🙂 After update not working ☹️☹️☹️☹️☹️☹️☹️

Guys why are you Upgrading the fucking Firmware?? Its just removes the Secret funcions

Then it’s broken lmao

That's true but just to be sure try hard reset. You can watch below video to learn how to do hard reset: kzfaq.info/get/bejne/oKl-o8Sny9vDeJc.html

@@TechAbetSolutions thanks so much! You're the man

It may have a problem with the power switch. It is better for you to take it to mechanics.

harbi la fsgvfykkj

Puedo causar daño a la bocina si la está usando mucho en este mode

It does not mean that any time you use it, your device will be affected. It can be harmful when you listen music very loudly. In normal mode, as explained in the video, the limiter is active and it does not let the speaker to be defectively loud. But in low frequency mode, the limiter is not active and at some level there is probability that your speaker can be harmed. It is like a circuit breaker in electricity. I don't prefer to take this risk and I just want to warn JBL Xtreme users. Besides its very important side effects, some youtubers advice people to use it in low frequency mode without any warning. That's why I wanted people to learn this risk.

@@TechAbetSolutions yeah.... I kinda tried without and it got even louder. But then the bass isnt good at all. I prefer the lfm but the speaker isnt harmed yet. I have been using it for a year now and its been aleays on max or at least 75%

Same i got lfm out of the box too i think cause pressing the buttons makes the bass lower

normal mode bass so bad on some normal people music, just for bass and high freq songs jbl is good

It didn't came with it turned on, it actually makes bass worse. Only low notes are played well, low, mid and upper bass. No weird bass boosted songs, try rebasses of songs and you'll see.

Plss help guys

Actully nvm its better when its on lfm

He told you so… 🤣

Plug it in and turn in on will anlo rest that mode your in which is off mode the plug rests it. Hope that helps

@@MarkBrown-ku5jx not working

Next update date??

Try to hard reset the speaker with the help of below video: kzfaq.info/get/bejne/oKl-o8Sny9vDeJc.html If it does not work, than you should have mechanical problem. The reason may be: 1-You may used your JBL over powered and this may cause one of or both of your speakers to be blown. 2-There maybe loose contact problem inside of your JBL If you still have warranty send it to the JBL.

@@TechAbetSolutions i send they nothing find

Mine has still 2.3 for the firmware and there is no upgrade available right now for regular users. I guess 2.4 is at the trial mode now. For cancelling the low frequency mode, you can hard reset (+ sign and play button for 10 seconds) your JBL to have normal mode.

Yup just got mine and the bass is louder on the normal mode

@@AXELVISSERS same

my guess is it disables a high pass limit on bass and other filters. so if u send sub bass to it, it will play it. in normal mode it boosts bass but cuts and limits sub bass with tricks and reduces highs to better match loudness of lows.

You can use it, but with caution. If you use it with very high volume, than it may be harmful to your speaker

@Bass Tester229 engrish

I do not use professional or high quality recorder, so sound may be different than the original one. Besides this video does not aim to show the sound differences. I am only trying to show how you can access 3 secrets about JBL products.

@Water Bass Tester yup on max volume it has LOUDER bass. Not more bass

Lfm isn’t Bass it just makes the woofers move Moree then they should it’s not tru Bass

yes it's the mic

That didnt work for my JBLExtreme 2 speaker too. The Bluetooth and up volume.

Probably because it's bluetooth+volume down

@@cloroxbleach5771 its lfm

whats your fimrware version? seams newer firmware has it disabled :(. did u update firmware?

@@nkaujthao3781 whats your fimware version?

New jbls doesnt have anymore

Why did it break?

IDK it was a little old so maybe that.

Hahahahaha

You should train your English a bit more then

All i understood is jbl xtreme 2

I thought I heard him say something about a free blizzard at DQ 😀🤷🏼‍♂️

that can break your speaker because in low frequency mode there’s no limiter

know anymore? did it disable the dsp eq and compression, etc?

But that is not advisable as explianed in the video. It is like circuit braker for electricity

@@TechAbetSolutions might try adding a boost converter to the battery and have it hooked up to the dc port so I could get max power

@@tlrautomotive8410 I am not expert on this subject, I am just a regular user but looks like you have the solution, worth to try for anyone who knows what he is doing...

You can use the same method as xtreme 2

wait how to i know if its in normal frequency

both the buttons lighted up

doed that mean its in normal mode?

its sounds louder

Beacuse we should buy sony xb43😂

@@aztech6436 not at all lol

Because It deactivate the DSP protection so the speaker go full power without any protection and honestly it makes your JBL sound like a cheap Chinese speaker hahaha

Beğeniyi ben yaptım. İngilizlerin aksanı Amerikalılardan, Amerikalıların ki Avustralya'lılardan farklıdır. İnsanların aksanları nereden geldikleri hususunda bilgi verir. Yine bir Arap, Rus, Çinli, Hintli veya Afrika'lının aksanı ve hatta konuşurken kullandıkları kelimeler bile nereli olduklarına dair ipucu verir. Yalnız ait oldukları dil grubundan olsa gerek Türklerin telaffuzları diğerlerinden tamamen farklı. Bu arada çok şükür ki Türk'üm...

@@TechAbetSolutions dedim abi tanırım diye. 😃 En yakın arkadaşımla en büyük kavgalarımız genelde bu yüzden oluyor. Mesela 20 senedir Amerika'da yaşayıp ciddi para kazanan ve çok akıcı konuşan bir iş adamı için adama bak 20 senedir Amerika'da çok kötü konuşuyor gibi eleştiriler yapıyor. Sanki zorundaymış gibi. Sanki adam orada doğdu büyüdü. Bu konu çok uzun ama kısaca yabancı dil konuşabilmek ile yabancı dilin köpeği olmak arasında fark olduğunu ve yabancıların Türk gibi konuşması gibi bizim de yabancılar gibi konuşmamıza gerek olmadığını düşünüyorum. Ayrıca video çok yararlı oldu. Teşekkür ederim.

Is it possible to go back to the older firmware

@@AhmadKhan-ow9qh no ):

Yea fr I was just tryna switch modes n shi wasn’t workin so I’ve been lookin every we’re for a vid saying it doesn’t work anymore n now I got my prof tnx g

How

Thats because its on a recording, in person you would

Really

​@youtubeblonde3958how