Flower 3D rose pendant - How to make handmade jewelry - wire wrap jewelry making
This 3D rose has been requested many times. I tried it for the first time in early October 2017, but failed. At that time I did orchids 3D to replace. After many attempts, I finally succeeded.
After finding the way I see it is not too difficult, not high technical requirements, Just be careful and persevere, you will succeed. With this flower I take 4 hours to complete
Hope you have asked for this pattern will pleased.
3D roses can be used as pendants, rings, hairpin, brooches or decorations
You can use the same set with leaf bracelets and leaf earrings.
The pendant has a complicated design, so I make earring and bracelet simple pattern to overall harmony
With creativity you can change some details to create your own style
wire size to make flower 3.5cm diameter (can + a few centimeters to depreciate)
22 gauge ( wire diameter 0.7mm ) : 70cm( 28 inch)
28 gauge ( wire diameter 0.3mm ) : 1200cm( 470 inch)
TIPS :
- Before doing, the wire should always be straightened, to bending is even and more beautiful
- Can use a towel to straighten the wire.
- Bending wire by hand to the product soft and natural
- It is difficult to see the wrapping clearly, so wrap as you like
- Cut 1-2m wire to make it easier to wrap
- Bend the petals to flowers look more natural
- Can be replaced with silver wire or gold wire for jewelry more valuable
Or simply use cheap material like copper wire to make gifts for friends, family or for yourself
- I just give way reference, not the best way. Can change size wire to suit your purpose. You can do better than me.