5th gen Toyota 4Runner rear parking brake adjustment

Рет қаралды 49,508

4 жыл бұрын

Пікірлер: 43

@holycannoli8562 2 жыл бұрын

After a nightmare brake job this weekend, I have some words of advice to everyone doing this... 1) if you increase the brake too much and the rotor turns enough to move the "window" to the brake setting, you may not be able to spin the rotor enough to align it again, thus not being able to loosen the spring again to get the rotor off. 2) I have had OEM toyota rotors that had holes which did not align properly with the adjustment hole, which makes it impossible to turn the spring...do NOT tighten the spring with the rotor off and then place the rotor onto the hub to check tension because it may not come off again. 3) be EXTREMELY careful using the M8x1.25 bolts to pop the rotor off and do NOT attempt to use this method if the rotor is stuck because of the parking brake. You can and most likely will crack the rotor and damage the parking brake.

@volvoturbo1 7 ай бұрын

Pulling the parking brake handle 3 or 4 click then adjusting the brake turning the adjuster to tighten will prevent this from happening. You then release the parking handle to the resting position and presto, brakes are adjusted.

@kspo193 2 жыл бұрын

Thanks for posting this video, it was really helpful when adjusting my fj. My parking brake works again!

@MichaelRungPhotography 2 жыл бұрын

Thank you for actually showing the adjustment wheel. Other videos I found didn’t explain or show that actual part clearly.

@driojal 3 жыл бұрын

The parking brake for the 4runner and GX470 are the hardest ever. I wished they have the open port from the back to do this while you have the tire on. Great video

@aguyagirlandatrail 3 жыл бұрын

Yeah it’s not the best setup, I prefer to adjust with the wheels on as well.

@willferrell2266 3 жыл бұрын

Thanks didn’t know they made em taught like this, was yanking on the rotor and the keeper for one of the springs came off the front, now I gotta fish it all back togethor.

@jimbederka6388 Жыл бұрын

I know your post is 2 years old but I did the same thing and had to fish it together in that narrow space. I am sure you have figured out how to get them on by now. I used zip ties to compress the inner springs and then fit everything into place. That made it so much easier. Then after everything was locked in place, I cut the zip ties to expand the springs. It worked so well.

@Martinko_Pcik 3 жыл бұрын

Excellent detail showing what the adjustment screw does. Turning it towards the wheel center expands the brake and increasing the drag.

@Me-zo8yc 2 жыл бұрын

Thank you for putting it like that. That makes perfect sense

@seanpop2886 2 жыл бұрын

On some Asian cars is up on the passenger side, but down on the driver's side... What about Toyota?

@niknik5380 Жыл бұрын

@@seanpop2886 yes that is exactly what my 4runner does.

@seanpop2886 Жыл бұрын

@@niknik5380 Thanks. Sometimes people will post things and not think about the entire process. Your confirmation is helpful. I have not had a chance to dig into my parking brake adjustment just yet. Knowing this not only saves time and physical effort, it makes an adjustment much simpler. Three clicks and check... 👍🏼

@NorthwestAdventurerNWA 3 жыл бұрын

Anti-Seize works well when installing rotors.

@jonathanl2748 3 жыл бұрын

Good video! Thanks.

@BenFreedmanRacing 4 жыл бұрын

Thank you

@isaacpala 10 ай бұрын

You are doing the adjustment with the parking brake not engaged correct?and the last thing you said about backing it up with the parking brake I didn’t understand,would you mind reexplaining that please?thanks so much for the video and help

@jeffreymelito3003 3 жыл бұрын

Thanks. Huge help!

@gidayfantaye7803 2 жыл бұрын

Thanks

@chieflouie2821 3 жыл бұрын

Front side parking shoe is thin, need replacing?

@JonFox1945 Жыл бұрын

Try to replace the brake shoes themselves on this car, it's an absolute monster

@j.brouwer5793 3 жыл бұрын

Proper way is click up till it's maxed out then two clicks down.

@davidjimenez2002 2 жыл бұрын

Is this with the parking brake engaged?

@danmidkiff5416 2 жыл бұрын

@@davidjimenez2002 this adjustment is done without pressing the pedal. The e-brake must be disengaged. If your pedal is pushed in, engaging the e-brake, you'll never get your rotor on or off. When you push the pedal down, the e-brake shoes will expand. Before trying to remove the rotor, make sure the pedal is disengaged, or you can damage the e-brake components trying to force the rotor off. Hope this helps.

@JohnnyRed79 4 жыл бұрын

Thanks.

@johnblandy8268 4 жыл бұрын

Excellent video. Tip for installing p.i.a. spring. Compress spring and tie with 2 pieces of thin string or wire before installing. Remove tie with small cuter after getting slotted cup positioned on pin. I wasted more time than I care to admit doing this.

@keshiakagihara-alexander2604 4 жыл бұрын

How do you attach the springs back on if they fell off? (The springs that have the pins on the brake shoes) please I need HELP!! Can anything be removed to make it easier?

@robopaul9 4 жыл бұрын

I don't think there's much of a trick to it, just keep trying and be patient. It's definitely a bit of a pain because of the tight space to work in but use a finger to hold the pin and use another finger or two to compress the spring.

@aguyagirlandatrail 4 жыл бұрын

A panel popper trim clip tool works pretty well. Hold the pin from the backside and compress the spring and the retainer down over the pin with the panel popper, it doesn’t take much to get it to grab a bit then you can rotate the retainer your fingers until it clips in securely.

@axios76 8 ай бұрын

Which way do you tighten? Pushing the jagged wheel up or down?

@murphyslawroadside 7 ай бұрын

Up tightens down loosens

@68paulie Жыл бұрын

In order to get rotor off is that required on both sides or just one side

@68paulie Жыл бұрын

Both sides as in passengers and drivers rotors

@aguyagirlandatrail Жыл бұрын

Depends on how they are adjusted, but typically both sides

@NALEXD91 2 жыл бұрын

Is this only in one side or both?

@aguyagirlandatrail Жыл бұрын

both

@Me-zo8yc 3 жыл бұрын

This is great as I now understand what the mechanism itself looks like and how it works, rather than just "Turn it up and back down again" Thank you

@anthonyhitchings1051 Жыл бұрын

these hat-style parking brakes suck big time - especially in Jeep Liberty 2008-2012

@december12ist 8 ай бұрын

i wish people would show their failures because this idea didn't work for me and I feel this didnt work for you either the first second or 3rd time..

@jroddy1 8 ай бұрын

Completely useless video if you don't tell the people which direction you need to push on that lever up or down??

@ralphcall4322 7 ай бұрын

Watch again. He clearly shows and explains which direction.

@chadspinalbosd007 4 ай бұрын

Did it make a weird noise when driving ?