AC Cobra Replica by Factory Five. Kit built by Randy. Specs, Build, and Half Mile Run

Рет қаралды 2,708

2 жыл бұрын

AC Cobra Replica kit from Factory Five, built by Randy, who talks about the Specs and Build of the Cobra. Making Half-mile run at NoFlyZone by OmegaMotorsport - Gila Bend AZ
Video by: coolcarvideo.com/
#shelby #cobra #accobra #shelbycobra #factoryfive #factory5 #noflyzone

Пікірлер: 13

@jdude9002 2 жыл бұрын

Supercool

@randyflores4559 2 жыл бұрын

I've made some improvements. Part of the vibration and rattling was a hood lock that came loose and allowed the hood to vibrate and shake wildly, and poorly balanced front tires. I've also added an airdam to the front end. I'm going back on December18th to give it another go!

@BradThePitts 2 жыл бұрын

Great car! Not everybody has $250,000 plus the need to break 200mph. Your 360hp Factory Five is about the most bang-for-the buck one could possibly find, not to mention you can drive it every day!

@randyflores4559 2 жыл бұрын

Absolutely! It is a blast to drive and worth every little penny I spent building it.

@litewatch 2 жыл бұрын

Change those front tires less balloony less sidewall 40 series tires cleanup alot of that shake Nice Cobra replica Built how He wanted 👍

@COBRATV427 2 жыл бұрын

😍 👍

@CoolCarVideo 2 жыл бұрын

Super chaîne que tu as là

@mosh1999 2 жыл бұрын

If the car's suspension is still set as in this picture and you are having alignment issues, it is due to your upper ball joint plates being mounted to the wrong sides.

@CoolCarVideo 2 жыл бұрын

cool thanks, I forwarded your comment to the owner

@johnarthur5692 2 жыл бұрын

Those tall front tires are also part of the problem, too tall, too much sidewall for high speeds, they look like 15" try an SS radial 235- 60 car will handle way better. Much safer too.

@randyflores4559 2 жыл бұрын

@@johnarthur5692 Thanks for the feedback. I have already been shopping for better fronts! : )

@johnarthur5692 2 жыл бұрын

@@randyflores4559 I agree with the first poster, please check the FFR build pictures, the ball joint plates look upside down. The angle should level out the ball joint depending on whether it sits above or below the piviot point of the upper control arm mounting shaft.

@randyflores4559 2 жыл бұрын

@@johnarthur5692 That picture is from the build process. It was corrected at final assembly.