Acura RSX Front Lower Control Arm Replacement DIY

No video

Acura RSX Front Lower Control Arm Replacement DIY

Рет қаралды 3,796

Күн бұрын

We're starting to bring back to the Acura RSX back to its former glory, specifically with its suspension. I'll show you how to replace lower control arms (LCAs) on a Honda/Acura with McPherson strut setup.
Part Numbers:
Moog Front Right: RK640287
Moog Front Left: RK640288
#acura #acurarsx #diy #carrepair #suspension #k20 #jdm #6speed

Пікірлер: 17

@werdgawd 9 ай бұрын

Nice detailed video as always! Appreciate your knowledge that you are passing on to the community!

@werdgawd 9 ай бұрын

Another thing I like about your videos is you appreciate the older generation Honda’s! I would love to over haul one of my first Honda’s… 86 Honda civic si!

@ElonJay 2 күн бұрын

Ideally, you should torque everything to spec when the suspension is under load.

@ipdjbt 9 ай бұрын

Must be nice working on a rust-free car! Those rear bushings should be torqued with the vehicle at ride height.

@kevinhernandez1700 4 ай бұрын

I was gonna ask about that , I learned in school you always gotta pre tensions these things before tightening right?

@unlisted5152 8 ай бұрын

How long did this take you? (Btw great video. Thanks for posting)

@randomrebuilds 8 ай бұрын

Maybe 2.5 hours taking my time. Not too bad time wise.

@unlisted5152 8 ай бұрын

@@randomrebuilds thanks. About to do this for my gf’s car and needed a good baseline for the time. Doing a full suspension, control arms, and rods. Should be a fun project.

@jesseruiz5680 4 ай бұрын

how are the Moog brand parts holding up? I heard the brand isn't as quality anymore these days.... thanks - 2005 RSX owner here.

@jesseruiz5680 4 ай бұрын

please le me know, I liked and subbed to get your attention lolol

@randomrebuilds 4 ай бұрын

@@jesseruiz5680 so far so good - no complaints on them from the past few months. Held onto my stock ones in case the Moog bushings goes out and I’ll just have to press in new ones on the OEM control arms.

@jesseruiz5680 4 ай бұрын

@@randomrebuilds was the improvement significant? And thank you for the reply, I’m considering replacing mine soon and will go either K-Tuned or something close to OEM. Just very picky and indecisive right now.

@randomrebuilds 4 ай бұрын

@@jesseruiz5680 definitely a smoother ride with the new ones. The front OEM bushings were torn.