Air Core Motor Arduino Control
Рет қаралды 1,554
2 жыл бұрынIn this video i'll be showing you how to use an arduino to control an old analog air core gauge motor. These things are cool when you get them working!
@mitchellhine1914 Жыл бұрын
Thank you, I’ve been looking ages for this
@jacoannandale3307 2 жыл бұрын
Thanks a Lot.
@dodge73dart 6 ай бұрын
I have these motors in a gauge cluster. Would you be interested in taking a stab at solving a mystery about what is wrong with the speedometer? It registers say 60 when the actual speed is 30 and 100 at 60 etc. I have more info if your up to the challenge. Others are stumped. Thanks
@Dutch3DMaster 21 күн бұрын
Check if increasing the PWM frequency helps (that is, if you are dealing with a sim-rig :P ). The default is around 490 Hz on some pins, and 392 on others. I am using a Kienzle 1318-27 speedometer and it uses the tone(); function so it is different, but some of the smaller gauges in my sim-rig respond much more accurate with higher PWM frequencies than with low ones (along with not "singing" as loudly as well :P ).
@mannbapna1255 Жыл бұрын
Can u pls make a new arc reactor project the once you did like 11 yrs ago
@jacoannandale3307 2 жыл бұрын
Is it possible to post the code ?
@Nikolas_A Жыл бұрын
+1, I'd like to have a look at the code too...
@johnger Жыл бұрын
Hi, code please
@sajidmohammad3190 3 ай бұрын
Good video with a bad thumbnail is very harmful 🙂
Articulated Robotics
Рет қаралды 321 М.
Creative Hacker
Рет қаралды 79 М.
Fixed Until Broken
Рет қаралды 1,5 М.