You're the best man! Thank you! Looking forward to my install now with the knowledge gained from your vids! ~ 🚗

Hey bud great video. Where did buy your fittings for the water trap? I have a 3/8 NPT and I can’t find a reducing nipple for it.

This was a really informative and helpful video, thanks a lot. I'm about to install Airlift V2 air suspension to my MK3 Vento VR6 and was trying to find a good solution for letting the water out of the tank and control the water in my system beside the airlift water trap which goes between the tank and the manifold. Thanks again!

What fitting did you used for the tank to the water trap?

If I have my traps flowing into my tank would I need another trap flowing to the manifold?

Which way does the arrow point?

Thanks dude, great video!

I honestly never had an issue I have two compressors my manifold has two inlets I run a water trap on each one and I never ran into an issue of water being in the tank but I do have my drain just in case

Where did you order your air lift v2 kit from?

Dumb question, but which fittings did you use to connect the water trap to the tank and the water trap to the lines?

Why not connect the water separator between the compressor and the tank

So why do you have a water trap annnnd a water release line?

Is air suspension high maintenance? I’m buying a car with air suspension & I’ve had springs and coilovers on all my cars up until this point.

Put in a other electric valve in it with a button in the front and the line out the car. Easy :)

I got the same star wars fabric in mine bro #MandoXB