Groovy junkyard finds!

Glad that worked out for you Major.I did the exact same thing for my 2003 Ram 1500.I think they charged me like $10 for that module at my local U-Pull.

0:42 - If you loosen/remove the retaining bracket on the AC receiver/drier, you can rotate it up and out of the way while still leaving the refrigerant lines connected. That's how I did my blower motor. Even so, it's still a pain, but it makes it slightly easier.

I just put together my dash they airbag light came on Only the passenger side then I disconnected some wires that went to the old phone in the fuse panel. The third one up on the passenger side door fuse panel. Was the one that I had to take out to disconnect this wiring for that phone thing any Ideas on how to fix it or Do you think the module could went bed

👍

Hey Major, I got a question about my 99xj. I was installing my RC seat covers like yours. I removed the seats to do them. There was a small harness that was under the drivers seat. I had to disconnect it to remove the seat. It looks like the wiring could have possibly went under the carpet up to the center console. Is that harness to my airbag? If so, I did not disconnect my battery before disconnecting that pigtail. Should I still be good? Just asking before I start the Jeep. Thanks, God bless!

replaced my heater core about a month ago, my airbag light has been on ever since. we plugged everything thing back in. and it’s not the clock spring. not sure what it can be, any thoughts ?

Ques... My airbag light is on also, and my horn doesn't work either, would this be clock spring or the module control unit?