I totally agree!

Thank you for watching, Angela!

Glad it was helpful!

Of course! We're so glad it was helpful 😊

You're very welcome!

Glad it was helpful!

You should do the edge to edge first. since it's a single line then it will not be too bulky to cover. Overwise you would have to edit the design in software. I hope that helps!

Hi Karen, yes. Definitely bring it up at the end and then you can bury it.

You work from the middle to the right in Columns starting with a column A, then connecting column B.

DIME Print and Stick Target Paper: www.allbrands.com/products/59540-dime-pstp01-print-and-stick-target-paper-25-sheets

Hi Karen, I like using the largest size available for my machine when doing in the hoop. Barbara.

Glad it was helpful!

Hi Connie, the template she's using is the fifth one in Expansion Pack 5.

HI Lorraine, In your embroidery screen there is a needle icon with a + and - sign by it. Click that, then advance to the first stitch, or last stitch if reversed to see if the starting point. If you have a Luminaire or Solaris you can use the projector to line things up. I hope this helps. Barbara.

Hi Margaret, thanks for the feedback! We'll keep this in mind for future demonstrations.

Yes! Make sure you have enough backing on the back side to compensate for the designs hanging off the edge.

Hi Robin! Thank you for asking. We sent this information to Mark at Amelie Scott, and this is the response: Barbara - thanks for reaching out. I watched the demo video again, and I see where the confusion came in. Sadly, in the demo, Christine neglected to mention something: with Pfaff, Viking, Husquvarna (and maybe Singer) machines, you MUST create separate A and B templates. Christine was demonstrating on her BERNINA, so she took a shortcut that she explains in much more detail in our Academy class (and, Christine had been doing a lot of Academy teaching, so it must have just slipped her mind when she recorded the demonstration video). So… for a short answer, the customer is right: follow the instructions in the book when it comes to templates. The book says to create separate A and B templates, and you can’t go wrong that way. For anyone else who notices that Christine is rotating a single template, here’s a brief statement: with BERNINA, Baby Lock, Brother, and Janome machines, the center of the stitch field is in the center of the hoop, so you can stitch one physical template and use it for both the A and B files. Sorry that we didn’t give a good explanation of that “short cut” in the demonstration video. I hope this helps. - Mark

Does this stitching for A and B template, only if you have these machines applies to ALL END TO END QUILTING DESIGNS?

I’d like a little bit more info when doing columns first. It’s about the spacing going down the column - is it up to the quilter to determine how much space to leave when starting (say the A column) again or is there some measurement that is the better way when starting the next design? Hope I’m being clear in my question. I have Viking and also BabyLock sewing/embroidery machines but just haven’t gotten back into embroidery since a few years before Covid. And I do have a nice library of Kimberbell designs that. are still brand new🥴. Thanks. Great video % I understand now.