How to Adjust the Holley Idle Mixture Screws

Рет қаралды 11,023

11 күн бұрын

Check out my new website for Mustang parts and merch that I am selling - krusebuilt.com/
This is a KZfaq Short for the full video where I installed a new Holley Carburetor and I needed to get it dialed in on my 1966 Mustang Fastback.
There are quite a few steps to do during the process of setting up a Carb, but the KZfaq Short videos are limited to 60 seconds, so this is only part of it.
The car is a 1966 Mustang Fastback with a 347 Stroker and T5 transmission.
Shot with GoPro Hero 9 with the Media Mod, edited on Davinci Resolve 17.
Gear I use:
GoPro Hero 9 Black - amzn.to/3ZCTpP7
Media Mod for GoPro Hero 9 - amzn.to/3CPKOi2
Rode Wireless Go II mic kit - amzn.to/3iJrj4c
GoPro Hero 8 Black - amzn.to/3QLpj7V
Media Mod for GoPro Hero 8 - amzn.to/3ZCAeoA
GoPro Hero 5 Black - amzn.to/3XuKMUQ
GoPro Karma Gimbal for Hero 5 - amzn.to/3GIWa8P
Credit for the music in the video:
::::::::::::::::::::
Epidemic Sound
Try it today! www.epidemicsound.com/referra...
::::::::::::::::::::
#krusebuilt
#kruseview
#Mustang
#1966
#fastback

Пікірлер: 10

@rickyfulks6656 7 күн бұрын

Always did it by ear in the day

@AndyKruseChannel 6 күн бұрын

Yeah, but that came from experience, you couldn't do that the first day you were introduced to a Carb. Most of my videos are geared towards those with little-to-no experience, giving them some tips and tricks along their journey. :)

@1833marine 8 күн бұрын

Good Info. Thanks for sharing!

@AndyKruseChannel 8 күн бұрын

Any time!

@bobbydelamar606 8 күн бұрын

I want to do this but I can't even get my car to idle. I have to open the throttle to get it to stay running.

@AndyKruseChannel 8 күн бұрын

Idle ports may be plugged, curb idle set too low, choke not adjusted correctly, accelerator pump not dialed in, etc. It’s tough to diagnose without knowing more, but those are some places you can start. 🙂

@bobbydelamar606 8 күн бұрын

@AndyKruseChannel I appreciate the help. I checked base engine timing, adjusted idle and idle screws, cleaned idle ports, replaced fuel pump, points and condenser, etc. I just replaced the intake gaskets and got a different carburetor. I'm about ready to start it again. Hopefully the carb fixes it.