Arctic Cat CV Boot Replacement (Old Style)

No video

Arctic Cat CV Boot Replacement (Old Style)

Рет қаралды 83,386

8 жыл бұрын

This procedure apples to 2016 400 and 450 ATV models. It may also apply to previous generation ATV and ROV models - check your service manual for verification.
It should be noted that the clips included with the boot kit may not be identical to the old clips but will work the same.
The part number for the CV boot clamp tool is 0444-120

Пікірлер: 24

@jackalgolfer3382 3 жыл бұрын

Best video on Cv joints and boots. Clear speaking, great lighting, and not a bunch of extra talking!! Great job!!!!

@daveordos5868 3 жыл бұрын

Thank you, Gives you the info needed to do the job!!

@izom 6 жыл бұрын

7:35 the clamps you put on like much better then the one u take off...all boots should come with these !

@wildtrophyhunts300 7 жыл бұрын

Thanks for great video!

@christhefistful 6 жыл бұрын

Thanks very good video.

@ryanmassengale5652 Жыл бұрын

Good video, it helped me for sure. But why couldn't you just take off one side and slide both boots off? Guessing making sure properly greased?

@seanfraser8442 7 ай бұрын

Good vid! Thanks!!

@YourLocalHandyman 4 ай бұрын

I followed your instructions to replace a CV Boot on the passenger side front of my 2012 Arctic Cat 700 Mud Pro H1. I got that done, but when I went to test it, my ATV now has a clunk in it towards the back when I shift from Reverse to H or L. There's two things I did that might or might not play a part. While I had it jacked up I shifted it out of 4X4 so I could rotate the axle hub. The second thing was I rolled the bike ahead while it was in N and on the floor jack. Any ideas appreciated. Thx.

@luciocarranza193 5 ай бұрын

Thank you

@ernzthomas2676 5 жыл бұрын

I have a Arctic cat h1 2007 my boots are gone and need some help I don’t have any way to fix them

@rugby3874 4 жыл бұрын

Thanks

@federicogambini8922 Жыл бұрын

hello, for an arctic cat wildcat 1000 year 2015 is it the same? thanks

@kountryquads9475 7 жыл бұрын

i have an 2003 arctic cat 250 and was wondering if i pull the cv axle out will all my motor and transmission oil come out sense it is all one unit?

@gavinpilkington3951 7 жыл бұрын

Kountry Quads if u tilt the side that u remove the axle from slightly higher then the other it will not drain out

@outdoorguy845 4 жыл бұрын

Very good information. But I would not hit the bearing with a mallet. I would put a deep well socket or a pipe over the threaded shaft and punch the bearing in

@Mr.Chronic 8 ай бұрын

hey im getting volt on my 06 arctic cat dash have you ever had this

@patrickedwards4239 10 ай бұрын

I have to replace the boot on the secondary drive assembly, Artic Cat part #3435-067. 2002 500 auto Atv

@nathanielklemp7756 3 жыл бұрын

How do I remove the front axles from the diff on a 1998 artic cat 454 4x4..

@gregh2632 3 жыл бұрын

This is how to remove a rear axel. Check out the other videos, I’m sure the front is the same. kzfaq.info/get/bejne/iKl_etSekrSXlIE.html

@edbonnell5141 Жыл бұрын

Outboard CV joint removal...a few taps and yours popped right off. Mine won't budge, it looks just like yours. I went from light taps to hard smacks...won't even try to budge.

@ryanmassengale5652 Жыл бұрын

It's a pain. Hit from one side and switch to the other is what I did. After 5 minutes it finally popped off. There's a little ring inside holding it in place.

@edbonnell5141 Жыл бұрын

@@ryanmassengale5652 I spun it around and beat on it with and without a ling brass dowel. I didn't see the point of trying penetrating oil considering it is packed with grease. In the end I removed the other end.