Note that an inductance at the input to a closed loop switch mode system may induce instability. See: • Instability and oscill... • Correction to:Instabil...
Пікірлер: 23
@krish2nasa5 ай бұрын
Very informative, Thank you very much.
@sambenyaakov5 ай бұрын
Thanks
@PavolFilek5 ай бұрын
Thank you very much. I need this to my MPPT DC-DC BUCK 2-phase.
@sambenyaakov5 ай бұрын
👍😊
@zaikindenis17755 ай бұрын
Thank you for the video. So, the maximum current will no be higher than Uin/sqrt(L/C). And the same effect one can see in gate drivers, where we need high gate current in hard switching aplication.
@sambenyaakov5 ай бұрын
Yes, correct. 👍. Hold on to my next, eye opener video.
@nikolaivic99875 ай бұрын
Very nice. Keep in mind that LTSpice by defualt adds Rser=1mOhm to every inductor in the model to improve convergency. This can be changed to 0Ohmin Control Panel -> Hacks -> Always default inductors to Rser=0. Not sure though what is applied when L=0, whcih may be the rootcause of the difference in Energy you see :)
@sambenyaakov5 ай бұрын
All this is known. But...you missed the REAL question: is the loss with L dependent on R?
@zaikindenis17755 ай бұрын
@@sambenyaakov Interesting question, thank you. Intuitively, not. Battery provide energy E*q. And capacitor is charged finally to E*q/2 energy. So we always lose E*q/2 in heat, we assume charge save in the circuit.
@sambenyaakov5 ай бұрын
@@zaikindenis1775 Hold on to my next video on losses. Coming soon😊
@nikolaivic44805 ай бұрын
@@sambenyaakovI mean that the total energy is not measured only over R2 if Rser=1mOh, hence the difference between L=0 and L!=0 energies. L is irrelevant for the E 🙂
@sambenyaakov5 ай бұрын
@@nikolaivic4480 OK, Got you now. You are of course correct.
@biswajit6815 ай бұрын
Great insight...Sir could you please make video on smps input filter design with respect to voltage mode and current mode control and input filter impact on loop characteristics
@sambenyaakov5 ай бұрын
Will try
@petarsimic40975 ай бұрын
🙏❤
@tamaseduard51455 ай бұрын
👍🙏❤️
@sambenyaakov5 ай бұрын
Numero uno😊
@yinan87195 ай бұрын
Thanks Dr Sam Ben-Yaakov. Is that also concluded that no matter how large the inductance is the energy dissipation is the same? Also seems it may takes a bit longer to dissipate the same amount of energy than no inductance at all.
@sambenyaakov5 ай бұрын
Indeed. Hold on to my next video an eye opener.
@KratosGhostofSparta-pp1cr2 ай бұрын
Hi sir. I have a question about LTspice. Is there a way that add TI models in to ltspice and use it? Thank you
@sambenyaakov2 ай бұрын
You may be lucky and the model might be compatible, but if it includes non generic sources or syntax it will take an expert to convert.