Found it... I think!! Best ammo for my Savage 64...
Пікірлер: 20
@Hungrybird4742 жыл бұрын
If you notice the clip after 7 rounds inserted the rounds may not lay flat if they are not pushed all the way back . Look at the side and it’s usually one or two 1/8” not pushed back which makes the top round not stick up quite enough for insertion . Took about 100 rounds to figure out . Mine likes cci hollow point 40 grain or 36 grain , likes golden bullets , likes pretty much anything copper coated hollow points . Does NOT like solid leads as reliably as them copper plated hollows .
@MrGordonSean2 жыл бұрын
Thanks, good to know....
@tonkatank0452 жыл бұрын
my savage 64 loves the norma tac22 also. i can hit a 4" plate at 100 yards with about 8 inches of hold over, 7 out of ten shots. low velocity but very accurate
@MrGordonSean2 жыл бұрын
I agree, and good shooting!
@huntinfishinwithDwayne7 ай бұрын
Looks like Parma Woods, the range I go to.
@RH-54827 жыл бұрын
Thunderbolt is supersonic @ 1250 fps, while Aquila Rifle Match @ 1080 fps and Norma TAC-22 @ 1100 fps are both subsonic. My 64 likes subsonic for accuracy as well. I get similar results with CCI Standard Velocity 40gr @ 1070 fps. It has been said by some, the shock wave behind a supersonic bullet will eventually catch up with the bullet in flight and possibly cause some accuracy issues.
@MrGordonSean7 жыл бұрын
Thanks!
@nickwilliams6869 Жыл бұрын
How much are they
@jamesstratton44882 жыл бұрын
Thanks
@nickwilliams6869 Жыл бұрын
Im going to tey the thunderbolts
@MrGordonSean8 жыл бұрын
I only load 6 or 7 per clip because I have had feed issues.
@jonathanmcgowan77467 жыл бұрын
I have a Model 64GXP and was having feed issues, too. I have since taken a small wire brush and my Dremel and touched up the feed ramp on the mag so that it is now a mirror finish. I bought some additional mags and cleaned them up as well.As to ammo, Savage recommends 40 grain solid lead rounds. They use Federal Gold Medal Match to rate their 22 Rimfires. Since Remington Thunderbolts are 40 grain solids they should work fairly well. Any 40 grain high velocity ammo should work well. I use Federal American Eagle, Thunderbolt, CCI Mini Mag copper coated 40 grain solids and Wincherster 40 grain copper coated rounds. The Norma and other subsonics should work well as long as they cycle the gun.
@anthonyjaylen65023 жыл бұрын
a tip: you can watch movies at Flixzone. Been using it for watching loads of movies lately.
@brendanalberto81963 жыл бұрын
@Anthony Jaylen Definitely, have been using Flixzone for months myself :)
@tuckerkai7503 жыл бұрын
@Anthony Jaylen Yup, been using flixzone for since november myself =)
@dustind2928 жыл бұрын
Curious to know if you have any feed issues on your 64. I bought mine last year sometime and couldn't get it to feed consistently at all, especially when the mag was fully loaded. The gun shot accurate enough and I'm not much for just plinking as I am for precision, so I was content just loading them one at a time into the chamber. Since then, I've polished the feed lip on the mag and removed the barrel and using a Dremel, ground in a little bit of a feed ramp. I can now load 9 rounds in the mags and it feeds reliably every single time with no issues.
@MrGordonSean7 жыл бұрын
Sometimes I do have feed issues. I have stayed with just loading 7 and it seems to lesson any issues!
@Hungrybird4742 жыл бұрын
I did the same with a file on the clip and then polished the clips and the feed ramp l didn’t file the feed ramp on the gun just polished with a wheel on high speed until it got shiny and it s a lot better 👍👍
@johnnyraycampbell Жыл бұрын
So this was just standard .22? Not the .22LR? I just purchased one to teach my 10-year-old daughter gun safety & firing.