Hello man I had same issue on my mk4 pd150. Only at 3000rpm. I used firad 120% Gtb2260 vklr.... The problem is the timing .. thes pd injector are very hard to calibrate for idle flow... But if you pusch hard then they work absolut great as long you have enough Fuelcapacity.. You cand do a logfile with the injektor meassures and see if there is a big difference between them. If there is than get the pds calibrated again
@DoublShed2 жыл бұрын
Hey man, thanks for the response! I have been lead to believe it is a leaking injector seal (which I am waiting on parts for now) I will replace all seals on all injectors. Set lash and report back. I don't think it will be timing belt related as the motor was running happily in the old shell. But I will do the above and hopefully that will call it sorted!
@gamingwithsai68222 жыл бұрын
@@DoublShed hey when u uploading on your main channel. got my first alto ts315 pa speaker because of your channel. I hope to see more speaker videos.
@shueibdahir Жыл бұрын
Hey i have the exact same symptoms. Can timing problems also cause a very smelly exhaust during idle?
@ompalumpa5910 Жыл бұрын
had a similar sound come out of my dads old mercedes 200, 65 model, but only after it sitting for about 4 years and having close to no power on the battery, sounds like a misfire on one or more cylinders to me, but eh, im no mechanic, good luck man!
@shayshay19976 ай бұрын
disconnect the maf sensor, and leave it disconnected.
@BRUV322 жыл бұрын
VNT go brrrr
@cantartan9170 Жыл бұрын
hey hows the project been? any updates?
@N1tr0_fox2 жыл бұрын
Hi nice to see your uploading agein
@mhlengindlovu8450 Жыл бұрын
Do you know what could cause a delayed start in a 1.9 tdi polo if the battery and starter are new?
@sunilbfd5268 Жыл бұрын
Bit late but probably glow plugs if it was cold start
@hamzaattaibi51948 ай бұрын
Camshaft sensor can be bad i had the same
@cantartan91702 жыл бұрын
is this the axr code motor?
@DoublShed2 жыл бұрын
Certainly is!
@mrsvarke36342 жыл бұрын
High presure fuel pump?
@DoublShed2 жыл бұрын
No high pressure pump on these! Just the low pressure pump and the tandem pump on these
@GioTunedd2 жыл бұрын
@@DoublShed tandem pump is the high pressure pump. Do you have vcds ? To check the injector values.
@DoublShed2 жыл бұрын
@@GioTunedd after everything the whole situation was causing by the lightened smf! Just gotta figure out what clutch can handle some power in the 5 speed 😂
@GioTunedd2 жыл бұрын
@@DoublShed just your old flywheel, with sachs sre 4 puck clutch kit will do the jobb
@DoublShed2 жыл бұрын
@@GioTunedd had much experience with those and drivability? This seems to be the answer I'm getting everywhere. Matched with the SRE pressure plate
@carthingscts81394 ай бұрын
The problem is your injectors. You are running too much boost for this pd100 injectors. Maf n stuff doesn’t matter. Your fuel is too less