Blue&me roof mic, into an erisin ES8120R HU

No video

Blue&me roof mic, into an erisin ES8120R HU

Рет қаралды 1,462

2 жыл бұрын

The Blue&me unit was relieved from duty (as it was fully replaced by an erisin ES8120R), so in this episode, we will connect the factory default mic of an Alfa Romeo 159, to the aftermarket HU.

Пікірлер: 14

@jabbawonga3779 4 ай бұрын

Hi, I just wanted to say a big thank you putting this video together and sharing. It helped me hook up my 159 to a Sony XAV-6050 using the inbuilt mic. Worked perfectly first time with your wiring guide. Thank you!

@SteliosLiver 2 ай бұрын

Greetings jabbawonga3779, Thanks for your kind comment.

@antoniodelazzari8730 9 ай бұрын

Hi! I just connected pin 8 (MIC signal) and pin 24 (MIC GND) with a 2.5 mm TS mono cable (like the cable that comes with the aftermarket erisin mic) to the MIC-IN in the Head Unit. I used two Dupont 2.54 mm male pin, crimped to the two wires and insulated with a heat shrinkable sheath. In the settings I have selected MIC source as external, and the lowerest MIC gain. I can't get it to work, during the calls i hear some strange sounds and no voice. However if I use the aftermarket erisin mic that comes with the box it works. When I removed the Blue&Me I did a proxy alignment with multiecuscan to exclude the B&M module from the CAN settings (cause the KM was blicking in the cluster), but I think the original factory MIC should still work in any case. The factory MIC was working with the original radio. What could I have done wrong? What type of PIN did you use? Thanks!

@SteliosLiver 8 ай бұрын

Greetings antoniodelazzari8730, There was nothing special about the cables I used... I garbed the closest Arduino/raspberry jumper cables I found. I soldered them, to the unit default cables of the mic, and it worked.

@Zigger2k Жыл бұрын

Thanks !

@RagnoRosso 2 жыл бұрын

Εισαι καλλιτεχνης. Και τα αστεια σου πιο ωραια απο της βοηθου!

@SteliosLiver 2 жыл бұрын

Μα είναι χαζή... Αστείο ήταν αυτό που μου είπε? Ακόμα και ο σκύλος μου λέει καλύτερα αστεία...

@tamamboylekalsn 3 ай бұрын

I have a giulietta which has blue&me. It seems my mic is not working properly. Can I use an aftermarket microphone on blue&me unit?

@SteliosLiver 2 ай бұрын

Greetings tamamboylekalsn, It could work, but I can't say for sure. I don't have a giulietta, and I 'm not using the default fiat audio source (this is an aftermarket erisin HU) In your place, I would replace the faulty part, with a new one with the same factory code on it.

@tamamboylekalsn 2 ай бұрын

@@SteliosLiver after my comment i found a topic in an italy giulietta forum. apparently you can use blu&me unit with an aftermarket mic but i havent tried yet. a new whole unit costs about 120 dollars in my country but a mic is about 5 :D i will try it, original one is not working properly anyways

@kevh3113 Жыл бұрын

not navi unit type .

@SteliosLiver Жыл бұрын

Greetings Kev H. You are correct. :-) ES8120R HU wont even fit in the facia of a factory default navi unit, so obviously the car was not equipped with a factory navi unit. (I don't know if they have a different mic, but I seriously doubt it.) Nevertheless thanks for your comment.

@FotisFotiou Жыл бұрын

Χμμ, πως χαμήλωσες το gain του μικροφώνου;;;

@SteliosLiver Жыл бұрын

Καλημέρα Fotis Fotiou, Τα gain των input, ρυθμίζονται από τα settings της πηγής. Εναλλακτικά βάζεις ένα κομμάτι σφουγγάρι μπροστά απ' το mic της πλαφονιέρας και έχεις το ίδιο αποτέλεσμα.