I actually did this after beating on it with a hammer and tire tool for 20 minutes. I went to the old You Tube stand by and saw this. It worked like a charm the first time. Getting the board centered correctly is important. Can't wait till a friend or relative gets in a tight spot with a wheel and tire. I'll be the hero.

Worked like a charm. I knew I was saving the scissor jack for something.

I used your jack/trailer hitch trick on my mower tire this morning. Worked like a charm!! 👍

Wow this worked like a charm. Took me a couple tries as my setup was a little different but after a couple attempts it broke the bead no problem

Great video. Went with jack between tire and hitch, jack pushed it down. For those not using a tube, If not adding a tube, spray 2-3 second burst of starter fluid around the inside of rim and light it with lighter. Poof, tire on wheel then add air.

I was struggling with a tire and I found your video, worked great ! Thanks for sharing your method.

I wonder if leaving the tire on the ground and turning the scissor jack upside down with its bottom against the trailer hitch would be easier to use. Ill have to give it a shot

I love DIY KZfaq and people who come up with genius ideas and SHARE it ..... Thanks Hilltown

Lol, wish I had found this earlier!! I wrestled with my two rear lawnmower tires for about 3 hours today. My son and I finally conquered them but your idea, which is great, would have saved us at least 2.5 hours and a Goody’s powder!! 😂 Lol

Loved it, you even show the gliches where you had to retry it. Thanks!

This works but I had a bead that would not break this dint work what did work was my trailer hooked to truck and used the trailer raiser put tire under it and crank like your taking off trailer off popped off first time! Lawn service guy

Thanks- Worked perfectly! 👍 Used a floor jack

Nice. Thanks for the quick demo. I have the same problem, a ZTM that keeps gettin' rear flats.

This is a great idea! I will use my quick car jack to do this in a very similar fashion Today!

Good job, may try this method on my mower front tubeless tire that needs a new valve stem,

This was awesome!!!! Took a few tries but work!!!!!

THIS IS AWESOME, THANKS FOR THE HELP..

Thanks, worked like a charm

I ended up putting the jack on the tire itself because a trailer was hooked up to the hitch we’ve got 😂 got it to work though

Good idea! Thanks for the video!!!..😊😊

Great idea! I tried multiple prying tools, jumping, and hitting mine with a hammer. A few string cranks under a tow hitch and it popped off. Smart solution.

Should've just placed jack on top of tire with wheel on ground and let jack press against hitch tire wouldn't flip over as easy

Excellent

F-ing awesome. Thanks.

Just drive over the tire with your car, it works every time, only over the tire not the rim, of course remove the valve core first

Thanks buddy !

I'm trying to find an easier way to break a tire down(I like this idea) but need a better way to put it back on the rim. You have any tricks?

Dood seriously? Just stand on it jump around