BSA B31 Plunger Gear Box selector adjustment

Рет қаралды 2,622

Brian Alfonso

Жыл бұрын

A short video showing the adjustment of the gear selector on a Bsa B31 Plunger model and some lathe work

Пікірлер: 12

@singhkarm6520 8 ай бұрын

Good work

@retromechanicalengineer Жыл бұрын

A very neat job Brian. I'd be lost without the lathe. Best wishes, Dean.

@500dbd34 Жыл бұрын

Thanks Dean, cheers. The drain plug pissed out, back to the drawing board.

@retromechanicalengineer Жыл бұрын

@@500dbd34 That's a shame. Perhaps you can regrind the taper between the case and the original plug? Best wishes, Dean.

@shingerz Жыл бұрын

That was brilliant to watch good stuff👍

@500dbd34 Жыл бұрын

Thanks, glad you enjoyed it. Cheers B

@davidclapham1066 Жыл бұрын

Lovely job Brian

@500dbd34 Жыл бұрын

Cheers B

@russellblampied Жыл бұрын

Hi, and great video ,I'm having a similar problem where as my m21 go's into 1st,nutral and 2nd but that's it so would this adjustment something I should try and will it throw 1st and 2nd gear out,if you could help and advise it would be most appreciated ? thank you Russell.

@500dbd34 Жыл бұрын

Maybe, I got mine working OK after some trial and error with the adjuster. Problem was having to remove the exhaust, footpeg, and drain the oil. I ended up putting the outer case on with a dry gasket and no oil (it took 3 or 4 times) until I got ot working OK I even took it for a short road test before sealing the outer cover and putting the oil in. I hope it works for you, Cheers B

@russellblampied Жыл бұрын

@@500dbd34 Brilliant, thanks for your reply.