サーボ駆動羽ばたき機　アメリカチョウゲンボウ　
ServoFlapOrnithopterAmericanKestrel112　23.5ｇ　Flap motion and Flight Control
New CODEによる翼の動き
翼の動きによる飛行制御を理解するための動画と図を追加
操縦するための翼の動きとそれによって起きる効果を説明
Making Video List • Making of ServoFlapOrn...
--------------
Width 610mm
Length 270mm
Weight 23.5g
1cell 100mAh Lipo 3g　
Total flight weight 26.5g
2.4GHz PPM Rx
Arduino pro mini
BLUEARROW AF D43S-6.0-MG Micro Metal Gear Digital Servo
Dc converter to 6.0V
100mAh1cell Lipo
--------------------------------
I made new Servo flap system by Arduino with PPM RX
New Servo Flap System by K.Kakuta
1 Bilateral Servo Flap between Max high point and Max low point
- change max flap point (throttle stick) and change Flapping frequency(5chLS)
3 Change center of Flapping angle Horizontal (Ch1 aileron stick) and Vertical (Ch2 elevator stick)
4 Change flapping amplitude on each Servo (Ch4 rudder stick)
Increase flap amplitude of one servo and decrease flap amplitude of another servo
Setting : Set elevator and rudder and aileron stick Center-- 1500microsecond
Set 5Ch at Left Slider or other switch
Set throttle stick and 5CH at low max --1000 microsecond
Please use “Serial.print” and Serial monitor on PC
Arduino Pro mini board
PPM Receiver-- RX PPM signal input to D2 pin
Servo right --D5 pin
Servo left --D6 pin
Ground -GND pin
6.0V -Raw pin　1cellLipo 3.7V to 6V by step up DCconverter.
Arduino code is here: kakutaclinic.life.coocan.jp/SF...
-------------------------
Ornithopter,羽ばたき機,鳥,ロボットバード,RC,Servo,Arduino, AmericanKestrel, アメリカチョウゲンボウ