Рет қаралды 3,095
700mms commanded, 40SCV, 30K acceleration.
I wanted to put a better insulator on the hotend vs the ceramic. I didn't weigh it, but I think the glass setup is better. I was able to TIG braze the brass threaded portion of the TIG setup to the hot end. Prior I had it safety wired on. This is a bit more permanent solution. This way I can thread on the ceramic cup or use orings on the glass cup. *don't try this at home unless you are a good welder! The glass insulates the hotend to some degree(haha), and the fan does not affect the nozzle so much. Downside is the orings will decompose around 300C and release bad stuff in the air. Working on a better solution once my brain catches up and thinks of something.