Install cam bearings on 5.7l HEMI. Also talk about getting the old ones out.
Пікірлер: 9
@erichorne646624 күн бұрын
Great video . Bottom line do not use the aftermarket grooved bearings unless you clock them in between 1 and 330. The measured spacing on both sides was nice
@Hillbillygarage121524 күн бұрын
Thank you for visiting Eric. I am very happy with the way the clocking has turned out. I have great oil pressure and my trucks are running great. We look forward to seeing you back at Hillbilly Garage.
@Coach_VinceАй бұрын
Good job 👏 you’re much more patient than me!
@Hillbillygarage1215Ай бұрын
Thank you for checking in with Hillbilly Garage. Hope to see you back soon.
@mikethomas12453 күн бұрын
Nice Job! Doing this at the moment. Your video help me alot.
@Hillbillygarage12153 күн бұрын
@mikethomas1245 thank you for sharing. It's exciting for me to know I've been able to help someone. What exactly are you working on? How deep of a build is it?
@mikethomas1245Күн бұрын
@@Hillbillygarage1215 I'm working on the same engine you have 5.7 Hemi. When i bought the truck it has a little over 200,000 miles on it. don't know when the last oil change was. So I changed the oil and and drove it about 100 miles and spun a cam bearing and seized up and snapped the timing chain gear bolt that holds it to the camshaft. So I'm doing a full rebuild.
@Hillbillygarage121520 сағат бұрын
kzfaq.info/sun/PLVs8K55GyL-r5BRkWAxB5J1L0SxFhTlab&si=SwNYbwylcumYDRZj There are a few tips in this video link that might be helpful on your HEMI project. Be sure you pull all the oil galley plugs out and flush the entire oiling system
@Hillbillygarage1215Ай бұрын
kzfaq.info/get/bejne/rNOelqd-l7uzoKs.htmlfeature=shared This is the link to the Playlist on the whole journey on the #8 misfire on my 5.7 hemi