A how-to video on a small and easy repair of the ticking noise made by Can-Am ATV clutch
Пікірлер: 18
@400ex94t8 жыл бұрын
Wanted to thank you for this video! I just bought a 2010 800, and I could not for the life of me figure out what that noise was in the primary!
@153eddy6 жыл бұрын
Tyler Reome I'm glad I could help
@freshmaker5 Жыл бұрын
So you want the bolt to spin? You don’t want the nut to be cranked down tight?
@stewroot61875 жыл бұрын
I bought a tube of that iso flex, changed my belt the other day and couldn't figure out where I apply it. I changed the belt and just put it back together. Ever since then I've been having a loud noise. Any advice?
@153eddy5 жыл бұрын
You need to pull the one way bearing out. Carefull when you do as there are 2 springs and caps that will pop out. Grease the bearing race and the slider cap
@phillippardo57124 жыл бұрын
Could this be the culprit on a CVT transmission? My 2010 jeep compass is making a clacking noise upon acceleration and deceleration. Sometimes even when shifting from park to reverse or park to drive. It doesn't however make the noise when revved in park or nuetral. If you can help it would be greatly appreciated thanks!
@153eddy4 жыл бұрын
No. Car cvt's are a little different. Yours sounds like a loose or worn cvt chain
@phillippardo57124 жыл бұрын
Thanks for your response. Yes that's what I am dreading a transmission problem. I'm hoping it's maybe the axel. Keeping my fingers crossed for the best worst case scenario.
@charlesfriday6 ай бұрын
Hey, do you have to put a washer on each bolt for balance? I’m having this problem after a service from the dealer and I don’t want to pay them anything else. Looks east enough. Please advise.
@153eddy6 ай бұрын
Yes. Each bolt gets a washer
@jaydowwg81509 ай бұрын
Please let me know what the blue stuff on your ATV is?? Did u add that to the washer to get it on better??
@153eddy9 ай бұрын
It's blue loctite
@jaydowwg81509 ай бұрын
@@153eddy so do I add that on as well?
@153eddy9 ай бұрын
A very small dab on the thread to ensure the nut doesn't back off with vibrations
@jaydowwg81509 ай бұрын
@@153eddy sweet man thanks .it's been so long since I've taken my atv out I'ma make sure it's that first.if so I'm good to go. Thanks
@backwoodsvape48755 жыл бұрын
How are them washers holding up 5 years later???
@153eddy5 жыл бұрын
They are good. I've done a few other machines as well and so far no issues at all.