Thank you for this I didn’t have my harmonic balancer on because I wanted to test the timing and as soon as I put it on like you said it fired right up

My exhaust cam and crank gears are lined up perfect but intake gear is of by 5 teeth and I have a no start now. Is 5 teeth to far gone ? I do have a interference engine

In a 95 Maxima, if I mistakenly use the minor chain tensioner as the main timing chain tensioner, do you suspect it would cause a no start? I have spark, compression, and a good starter. I used starter fluid so we can rule out the fuel system.

I just watched a video right now I have a j 3.5 Acura MDX I replace everything and I checked all my timing top dead center when I start up the vehicle they ran for like less than a minute and the check engine light came on and then when I checked the code it was p0344 so could I be off timing from the cam

Well how can you set the proper timing when the eco tech I was working on the camshaft sprockets can only go on one way because of the notch on it

Hi i kept trying to start the engine on bad timing chain . Is it possible that i damagedy engine ?

#1 on compression stroke

👍👍

Hi mate I had my timing belt changed by a garage and when I start the car, the car was sounding like a rotary engine after driving it a week hoping it will go back to normal, the car shut down and only cranked but did not turn on and the same garage said the engine is done any clues ( is a 1.2liter vauxhall/ opel corsa) please help😊

Ok so, I thought it was the starter, then I thought it was the alternator cuz I replaced the starter still just cranks... I being told it might be my alternator or timing chain. All my sensors have been replaced my battery is brand new... what else is there ...please help

Timing chain replaced and power steering crunk up fine got gas came back home and once I turned in the drive way suv shuts Off