Checking Piston Ring Gap for 1.9 TDI PD ASZ / Verificarea tolerantelor segmentilor in cilindrii

No video

Checking Piston Ring Gap for 1.9 TDI PD ASZ / Verificarea tolerantelor segmentilor in cilindrii

Рет қаралды 3,069

WRC garage

Күн бұрын

Checking Piston Ring Gap for 1.9 TDI PD ASZ / Verificarea tolerantelor segmentilor in cilindrii

Пікірлер: 17

@robertoamato4644 Жыл бұрын

Bravo

@user-uh9vz5ij8d 10 ай бұрын

Corect exsplicat (profesionist)

@WRCgarage 10 ай бұрын

🙏

@unofficialmusicvideo3441 Жыл бұрын

💯👏

@anapaulapereira3255 Жыл бұрын

@John-hv5sx 3 ай бұрын

In the manual it says to measure 15mm from the bottom of the cylimder do u think it makes a difference from measuring from top

@WRCgarage 3 ай бұрын

Yes, it does, you have to measure it 15-20 mm from the top or bottom of the cylinder to have a precise measurement.

@kelekilla 6 ай бұрын

Hello my friend!!! Im now just to make the same process than you in my 1.9 tdi ARL engine. everything is now dismantle !! But im really worry about to deglaze or not ..the cylinders they are in specs !! I measured it as you shown !!! But this is now my biggest doubt to deglaze or not because the walls are shiny!! Or just mounting the New rings as the cylinders are??i would like your conseill!!!

@WRCgarage 6 ай бұрын

As long as the cilynders are not too visible worn or bad scratched you can just leave them like that if they are in the specs.

@kelekilla 6 ай бұрын

@@WRCgarage thanks very much im gonna do as you said ....i prefer not to destroy my block with the cheap 3 pads stone jeje 😅!!! Im just changing rings for more compression!!

@WRCgarage 6 ай бұрын

I have changed that ASZ engine block aswell with an ARL last month as i found a better one with very little use in it and with still factory honing looking great .

@kelekilla 6 ай бұрын

@@WRCgarage thanks for your time !!! If for you worked with New rings and no honing .it is what im gonna do !!! Before i dismantle oil compsuntion was really low so i dont wont to leave it worse than it is yet!!

@alexallex2246 6 ай бұрын

Ar fi trebuit sa cantaresti pistoanele cu tot cu segmenti si biele... sa fie 99,9% echilibrat tot stii ce zic

@WRCgarage 6 ай бұрын

Bielele forjate vin echilibrate cu o eroare de +- 1 gram iar segmentii ar trebui sa fie la fel, pe mine ma interesa sa aduc pistoanele la aceeași greutate pentru ca din ele am frezat, o diferență mica de cateva grame e ok dar nu foarte mult.