Hello my friend finally with this new lights I can see better at night time and I hope this video is going to help lots of scooters owners to upgrade their lights and be more visible on the road thank you for watching my video my Florida friend and be safe

Hello Karol thank you for watching my video and be safe

Hello my friend Larry thank you for watching my video

Hello my friend thank you for watching my video

Hello Harvey thank you for watching my video

Thank you for watching my video

Hello my friend thank you for watching my video

Thank you for watching my video

I was just gonna comment this, I did this with these bulbs, and the exact thing youre saying happened one ride with a decent section WOT and got home and both bulbs blew the lowbeam circuits and the dash was showing my high beams on all the time no matter what I did wiht the switch. I ordered a 12v full wave rectifier and am thinking i hook that up to the yellow wire going into the lights low/high switch to see if that resolves the issue. Fingers crossed

Thank you for watching my video and have fun fixing your scooter

Hello my friend I'm very happy about this Led upgrade I finally can see at night ah ah ah thank you for watching my video

Hello my friend thank you for watching my video

Hello my friend ah ah ah thank you for watching my video

Thanks for responding sir you have great energy God bless you !

how do u take out the mealt brackets .

Great idea and thank you for watching my video

Hello Skipperdan 1 sometime they flicker at very low idle but over 0.500 rpm there is no problem in the video you can see more white led flickering because the camera recording frame does not have same frame alignment per second . Thank you for watching my video

Hello Lucas great idea I will think about that but in the seme time check the yellow wire coming from the stator and search for gy6 150cc electrical diagram that will help you a lot

Hello my friend that I’m not sure the best thing to do is to open your light and check the size

Hello my friend yes the led will flicker a little at low idle the only way to fix that is to upgrade to a larger stator with 8 to 11 poles or connect the leds directly to the battery . Thank you for watching my video

@@VirberelloScooterTips do you have a video for a stator upgrade lol

@@VirberelloScooterTips would a led resistor work ?

Hello Yenkna the quality of the red rear light is not there yet they burn little to easy but the front led light are good is your scooter is 150cc if your scooter is a 50cc light are not good and they flicker to much unless you connect them directly to your battery anyway thank you for watching my video and be safe

Hello Mark both scooter on the front they use s2 35/35 bulbs but you can use ba20d an t10 but to run them better you will have to run them from a stable 12 volts source like your white wire on the scooter or the yellow wire will make them fliker

@@VirberelloScooterTips Champion, thank you.

Hello the led light work great but they flicker a little so the best way to install them will be to go directly to the battery or the rewire from the regulator

@@VirberelloScooterTips Do you have a video you can link where you've wired the headlights into the rectifier? Im guessing its the Yellow wire in the headlight switch, that goes into the rectifier, and the positive from the rectifier goes into where the yellow wire was in the switch. Thanks! Great videos

Hello Joe I buy all my part on Amazon but some of the lights they do not last to long for poor quality

Hello Cliff my is a Eagle Gy6 150cc motor I like that motor because the parts are cheap and you can switch pats like a lego ah ah ah Thank you for watching my video and ride safe

Hello my friend yes the head light are easy to change you only need to remove the front plastic cover and remove the headlight assembly but the light bulbs are not easy to find at any automotive store because scooter use a lower voltage then cars but so I order all my lights on line but sometimes is possible that some auto store have them in stock

@@VirberelloScooterTips Thank you for your response. I took off the part which the headlights are in and they are covered by plastic and it looks it be easier to take the bulb holder out with pliers and take the bulb to an automotive store and see if they have one in stock?

@@m.joeymcgrath6842 sometime they have them make sure is the same watt because if is to many watt the light will run to hot and will melt the headlight assembly

@@VirberelloScooterTips hey there, I will un-Do the cover for the headlight and try to pull the light plug out with pliers and take it to one of the automotive stores or 2 places which may have the bulb?

Yes the led light flicker in the video camera but not in reality because when the frequency of the camera's frame rate per second (FPS) and the LEDs don't quite match, the flicker becomes visible on the camera screen the video has different speed and they working ok with ac for the 150cc scooter if you have 5 pole stator or more poles / heads in the stator now if you make the led light to work on dc direct from the battery they will work 100% better you are completely right . Thank you for watching my video and be safe

Hello my friend I'm not sure but check on amazon because they have more then one amzn.to/3n30ZOS just remove your light and look but if you have a 50cc scooter they flicker to much because the 50cc stator is to small but you can always run wires to the battery and fix the problem . Thank you for watching my video

all Chinese are very similar but if you have a 50 cc the led light will not work great because smaller stator and smaller battery

Yes they will work with one light scooter but make sure you have a 150 cc or more scooter because they have a bigger stator alternator or your like will flicker unless you connect the light directly to the battery

@@VirberelloScooterTips Ohhh ok I see. Mine is only a 50cc a Tao Tao Pony or ATM50.

Hello my friend that is a little strange make sure the lower part of the light is clean and the socket where you place the light is clean with no corrosion . Thank you for watching my video

Hello No unfortunately 50 cc has a small stator and on 50 cc the lights will flicker a lot more you will have to run the positive wire directly to the battery at that point they will work a lot better

Hello Duc Yes sometime they do. Thank you for watching my video

@@VirberelloScooterTips I think it's because it's AC to DC voltage. They have capacitors or something of the sort to fix that I think.

Hello Jimmie no I don't sell them but I buy all my products on Amazon check this amzn.to/3IXUaLN for on 749 dollars and free shipping with 5 stars not bad for the price

Hello Jalal you need to follow the wires and the connections and make sure you do not have any cuts in the wires or corrosion at wires plug connector will be great if you have multimeter to check if the stator is producing current on the yellow wire. I hope this can help you thank you for watching my video

@@VirberelloScooterTips Thanks a million Please keep making gy6 videos You are helping do many people Thanks again

@@jalalmaache573 thank you for watching my video s and I'm very happy that I'm helping somebody that needs help from me be safe my friend

Hello Bennie you need to test your stator with a multimeter to make sure you getting good clear voltage on the yellow wire and follow that wire to the front of your scooter to make sure you do not have any cut wires somewhere

Thank you for watching my video

Hello my friend the rear led light are great but they do not last long time because the quality is not there yet but soon we will get very cheap light at great prices . Thank you for watching my video

@@VirberelloScooterTips ok thanks but I want to change the front light headlights to the a red or green color do they sell bolts like that

Ah ah ah thank you for watching my video

@@VirberelloScooterTips your videos are excellent, just a little long winded sometimes. Absolutely great thoughts and showing how to do things though. I support you.

You actually do great shows. I just popped a LED light in place of the old lamp, and the spread and clarity is phenomenal, however my turn signals no longer flash. Let me know if your brain has any ideas.