Chrysler 3.8L transmission removal

Рет қаралды 18,656

4 жыл бұрын

This vehicle is a VW Routan 2011 ish i can't remember exact date. This will apply to any and all of the chrysler 3.8 vans of this generation. Be careful and patient when lowering trans to not bend the ring for crank sensor.
I also left in slme of the camera movement thinking it may help show where I'm working. Any and all feedback is appreciated!

Пікірлер: 19

@rockofalethia9387 2 жыл бұрын

yea, it has to go left (toward drivers side) to clear ring gear, then tilt forward to unhook the back part of the casing from the subframe and then move forward, then down.

@finkthreely7089 4 жыл бұрын

Nick great work man. The video thumbnails look awesome!

@CarMechaNick 4 жыл бұрын

Thanks!

@mianhaafi2251 4 жыл бұрын

Doing great job man ✌

@CarMechaNick 4 жыл бұрын

Thanks!

@marcusbostick3246 2 жыл бұрын

i have 2011 caravan got code for shifter solenoid . put it in and filter and fluid now it'll go in R but not D any idea why or what to do

@nickcruz2389 Ай бұрын

Hey I know this is an old post but I had at question. At -23:10 minutes, what is that cable you are pulling out from the top? Looks like you just use a screwdriver to unhook it

@nickcruz2389 Ай бұрын

11:36 seconds into the video

@josemartin530 3 жыл бұрын

Thank you for taking the time and filming it. Is this car a dodge gran caravan with the 62TE transmission?

@CarMechaNick 3 жыл бұрын

It is the same thing. This one a was working on was badged as a VW.

@josemartin530 3 жыл бұрын

Nice! Subscribed!

@CarMechaNick 3 жыл бұрын

@@josemartin530 awesome thanks!

@megatonesilva6546 Жыл бұрын

What swivel adapter is that on the end of your air hose? I purchased three IR units and they all began leaking air within a year of daily use. I'd like to get better quality. IR makes good stuff, but not that swivel adapter though.

@CarMechaNick Жыл бұрын

Oddly enough my swivels are from harbor freight. They're the cheaper ones, I've been using them for several years daily without any issues.

@megatonesilva6546 Жыл бұрын

After you had the motor & trans separated.........what was preventing the transmission from moving away from the engine block? Was it the subframe or the unibody rail where the trans mount goes?

@CarMechaNick Жыл бұрын

Sometimes the diff hits on the subframe. You have to tilt the trans pretty far forward if I remember correctly. I usually use a ratchet strp to secure the trans to the jack.