thanks man, someone told me that bump was a rivet and the crimps were like pinch welds and after i bend them off it'll never be the same. fkn obviously. glad I looked it up first. subscribed and liked
@bobblueton Жыл бұрын
my wd 40 was out as well (mine all do even if I hold them the right way) idk if you knew but you can take an air compressor needle and fill it back up in the valve to save the $2 or whatever was probably left in the can.
@d.j.99612 жыл бұрын
I also clean out the box magazine/cartridge section whether I need to just hit it with brake clean then oil or, rinse it out, dry it thoroughly then, OIL IT UP INSIDE & OUT Along with the spring, & cleaning up the follower or plastic part!
@Dowan_Gim3 жыл бұрын
Thank you for video.
@chadwickmeyer78443 жыл бұрын
You are very welcome. Hope it helped!
@coosabass49343 ай бұрын
Anyone here have a problem with the 702 mag from ProMag failing to lock in a Rossi RS22?
@tanawan.s18372 жыл бұрын
Merci beaucoup mon frère
@chadwickmeyer78442 жыл бұрын
Tu es bienvenue!
@oldrabidus22309 ай бұрын
Clean with brake cleaner. Apply Renaissance Wax. Buff dry.
@pierce8732 жыл бұрын
My rs22 is having a really bad failure to feed issue where the billet gets Jammed facing upward and it just isn’t working any suggestions?
@chadwickmeyer78442 жыл бұрын
Have you cleaned the feed ramp and the magazine riser?
@d.j.99612 жыл бұрын
There are other videos online regarding the Rossi feed ramp but, after a thorough cleaning of everything, including opening the magazine, seperate all the parts, either rinse the box/ cartridge in water then dry & oil, or brake clean it then, clean it & always follow by oiling the inside & outside of the magazine , spring & plastic follower plastic part. Some need filing to the feed ramp but only after trying SEVERAL OTHER CLEAN MAGAZINES!!! Some overlook the cleaning & oiling of all magazine's. I hope you get it feeding & operating properly!
@SilencedLamb693 жыл бұрын
If I cut some of that spring off could I make it hold another 1 or 2 rounds?
@chadwickmeyer78443 жыл бұрын
It probably wouldn't have enough tension to feed the last couple rounds.
@oldrabidus22309 ай бұрын
If I were you, I’d dabble on a new 3D printed base plate that sits 1/4” lower. And possibly a new Wolff spring in case the stock spring is now too short with the plastic printed base plate.
@d.j.99612 жыл бұрын
The Rossi RS22 magazine is the same magazine as the Mossberg bolt action 802 plinkster & the 702 plinkster!
@charliecross31989 ай бұрын
No it is not. Look at the back top slot of the Rossi magazine near the feeder, Then look at the same spot on the Mossberg Magazine. The Mossberg slot is narrower than the Rossi. So, you cannot use the Mossberg magazine in a Rossi 22lr Rifle.