Common Molding Defect: Jetting
Рет қаралды 12,675
2 жыл бұрынInjection molding polymer through small gates creates complex three-dimensional fluid flow behaviors. Jetting occurs in injection molding when polymer material is injected through a nozzle, runner, or gate at high velocity, into open, thicker areas, without forming contact with the mold wall.
@jamieevans6395 Жыл бұрын
You get this a lot with abs if you're injecting onto a flat surface hence why you should inject onto a wall of the component
@unidentifiedhandle 7 ай бұрын
Great video, it would have been perfect if example was shown to fully understand the final results! Thanks!
@KruseTraining 3 ай бұрын
Great point!
@FratDede Жыл бұрын
So what is your recommendations?
@jamieevans6395 Жыл бұрын
You will have to profile the first stage to try and control it and putting tool temps up will help
The Madison Group
Рет қаралды 3,5 М.
Goobertown Hobbies
Рет қаралды 469 М.
Essentra Components
Рет қаралды 35 М.
Orange Plastics Academy
Рет қаралды 9 М.