CV axle replacement 2011 Jeep patriot AWD

Рет қаралды 45,219

4 жыл бұрын

CV axle replacement 2011 Jeep patriot AWD. If you are wondering how to install or remove or replace a part on your car, I hope this video will help show you how to change it.
Check out Amazon's parts for your vehicle - amzn.to/2bIxfGJ
2020 has really shown me I needed to be better prepared for the future, start saving/investing now. Use some of that money U saved by watching DIY videos to plan for the future. Click to get started today.
Etrade - refer.etrade.net/thechoice1pr...
M1 Finance - m1.finance/CGW7TTw5ZqYQ Buy Fractional shares on M1 or Webull.
Get 2 free stocks with:
Webull - act.webull.com/nt/3hiKwUuORU2...
On Facebook Become a Fan! - / fixingcarsandstuff
Grab a shirt or hoodie to support this channel
www.printmotor.com/fixingcara...
This Channel provides videos for informational purposes only and cannot be held liable for injury, damage, problems that arise when trying to duplicate steps shown in videos because it is impossible to account for all possible circumstances and situations. Please do contact a qualified auto technician in your area before attempting any work you feel you are not qualified to do. If there is an Amazon link, and you go to Amazon through it, if you purchase anything there I will receive a commission.
Outtro music snippet, by: joshwoodward.com/ Good To Go - Josh Woodward
creative commons license.

Пікірлер: 27

@automashmo3234 3 жыл бұрын

I like the way you filming the steps. Thank you

@willsrestorations 2 жыл бұрын

Now that's how you make a fucking video on a repair job.

@valitino2704 3 жыл бұрын

Good job. Very helpful for me right now. Thanks.

@williamdyckman9704 4 жыл бұрын

Tod, very helpful video, thanks !!

@patrickwarden2933 2 ай бұрын

Always face clip opening on down side to make it go on easy

@oleksandrbreus 3 жыл бұрын

thanks! U video helps me!

@vianaautocenter258 4 жыл бұрын

Like! Good job!

@josecebrian4499 2 жыл бұрын

What’s the name of the fluid that came out ?

@hilham89 Жыл бұрын

Yeah you can use a 1/2 breaker bar or more like break the breaker bar itself.

@pameladesserre4605 3 жыл бұрын

how long does it take to replace, without coffee or lunch breaks ?

@nailedit1620 3 жыл бұрын

Thank you so much! Very helpful

@tedohio3038 4 жыл бұрын

👍

@brandonb5818 2 жыл бұрын

Why would you use grease? I thought the place you pulled it from was leaking transmission fluid

@IMKINDOFABIGDEAL13 Жыл бұрын

To hold the c clip centered. He said it twice while he was doing it

@Juanimo7 3 жыл бұрын

I cannot get my cv axle off my my 2015 Jeep Grand Cherokee. Driver side. Any advice?

@avicii6782 Жыл бұрын

Prybar it or try wrapping that boot outside the diff with a rope or chain and slide bar it to break it free

@simonchau8675 2 жыл бұрын

What kind of grease did you use to grease the ring?

@colinfromfreddybeach4652 2 жыл бұрын

I can tell by the color it's all purpose grease

@BrandoEhh50 Жыл бұрын

Jeep Patriot is 110 ftlbs tire lugs

@brandonjay5146 4 жыл бұрын

Can't get axle out of knuckle to save my life pb blaster 3 jaw puller map gas torch lightly avoiding bearing what an I doing aring

@johnmixon22 4 жыл бұрын

Try a two jaw puller

@d1lldojoe490 3 жыл бұрын

Invest in open shut instead of pb you’ll thank me later

@mattipps 2 жыл бұрын

How did you end up getting the shaft out, got the same issue here

@bradysolaem2467 2 жыл бұрын

I believe I used the shop press completely pulled the son of a bitch off that made short work of it ;)

@colinfromfreddybeach4652 2 жыл бұрын

Sometim they are siezed and just do not come out but I would try heating around the axle not the actually axle itself

@Jc-he2fi Жыл бұрын

You shop guys do everything the hard way🤦🏻‍♂️

@richardedward8046 Жыл бұрын

So you can just give a light tap holding the axle straight and it should go right in? It looks just that easy like that in the video, but then again im sure being a pro you make it look easier than it is, but my only other experience with this was pretty disastrous lol I ended up having the car towed to a shop just to install the axle, so needless to say I'm a lil intimidated about doing this. Thanks for the video, it was very helpful.