Good job.....here's a few tips. Anyone attempting this remember to use plastic tweezers, the Batteries are still fitted so parts of the circuit are live and could short if touched by metal tools. Next....there's far too much Heatsink Compound applied, components that get hot need close contact with an Alloy Heatsink and a thick layer of compound actually makes things worse. Use a thin film of paste to get maximum contact, DJI have used too much themselves which is silly of them. Finally the two Antenna are too close together and could cause signal damping, when doing this mod fit the connectors as far apart as you can. This also allows for attaching wide paddle type Antennas should you want to try them, that's what I use.

You explained me a lot. Thanks!

Thanks for english subtitles! :)

おーすごい。全然分かんないけどこういう作業動画面白いです。 察するに、より強い電波飛ばせるアンテナを後付けしたってことなんですかねー。

ここまでしてしまうと保証飛んじゃうけどやってみたい！

❤❤❤

followed the tutorial but after the ground drone got up I couldn't control it and it started going by itself. what is the problem?

Is it really worth it? I just can't see tearing my 300-dollar controller apart if there isn't a substantial improvement.

I’d have left the built in antennas as long as you cover the metal at the end it’ll be ok.

Cannot be used in Japan.??why?

how’s life?, マニアさん, super-great shots~do you want a prom?o-

how much range does it provide

What use is this video??? No flight test or pre flight test. How much difference does it actually make?

レンジテスト待ってます。

Is the connector IPEX MHF4?? Or MHF1 ?

これしきの事が違法になってしまうって、日本はどうかしていると思う

法的にマズいので日本語解説は無しですか

😱👎