Dodge Charger / Chrysler 300 ENGINE TICKING OR KNOCKING? Diagnosed (Rocker Arms)

No video

Dodge Charger / Chrysler 300 ENGINE TICKING OR KNOCKING? Diagnosed (Rocker Arms)

Рет қаралды 21,247

Күн бұрын

Do you hear engine tick or knock noise 3.5L V6 on your Dodge Charger, Chrysler 300, Dodge Magnum? Most likely Rocker Arms have to be replaced. It is a very common issue on this engines. Watch the video and compare the ticking noise to the one on your vehicle.
This can be fixed by replacing both rocker arms assemblies. It is a 3-4 hour job. Nothing too hard.Remove the intake manifold, valve cover and you will get access to the rocker arms.
I WILL RECORD THIS VIDEO WITH STEP BY STEP Instructions so don't forget to SUBSCRIBE...
Manufacturer Part #: 4892293AC
⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 13

@CarlosMalcolm-qn6ne 12 күн бұрын

Is safe to still drive it what the worst can happen

@QuiteAlright 11 күн бұрын

Well it should be fixed asap. Loose and loud rocker arms can cause increased wear on valve train components and even cause engine damage

@joshualeverson101 Жыл бұрын

How can I fix it

@curtiselsey7307 3 жыл бұрын

My engine having a *what?*

@michaelwashington2682 3 жыл бұрын

no info vid o

@fuckwitpeoria 3 жыл бұрын

👍🏾

@QuiteAlright 3 жыл бұрын

thanks

@fithace9487 2 жыл бұрын

@@QuiteAlright I have the same engine (07 charger 3.5) with a tap from what sounds like the top end. This comes at THE worst time for us, so getting a new motor or new car is not possible, and I cant do much work without it right now. Anyhow, replaced both rocker assemblies. Still racket in top end, so replaced both heads. Note: while replacing them, I noticed on cylinder 6 there were 2 very small (like half the width of a pinky nail) marks on the piston that appeared to be valve marks, on the exhaust side. I checked the head and valves and sure enough there was the smallest (paper thin, about 5/32 of an inch wide) shiny spot on the 2 exhaust valves. The valves still moved and seated properly. The damage on the piston was only superficial (basically just enough to show through the carbon build-up) no actual damage. So i replaced the head, got everything back together, oh, and set timing at TDC with both cam gear marks perfectly aligned with their respective marks after tensioner was tightened. In other words timing is spot on. I get in and crank it over, and it started up right away. It started quick. It runs as smooth as can be, no misses or backfires or anything. (no codes either, btw)... Just that annoying freaking knock that is still there! I am already thinking that after seeing the number 6 damage and the fact that the new head didn't change anything, so maybe a broken wrist pin or spun or worn rod bearing with just enough play to allow it to tap the valves???? I also considered even though the rockers seemed to have no play/in good shape, maybe one of the ones I just put in are bad too actually. As you can tell, I'm grasping at straws, lol. Did you ever make any more vids on this engine?

@trajic1428 3 жыл бұрын

So uh where is the fix video?

@QuiteAlright 3 жыл бұрын

sorry didn't make one. I wasn't the one replacing the rocker arms in the end. Will do it on the next charger or 300 we get in. Most of 3.5L have that problem

@fuckwitpeoria 3 жыл бұрын

@@QuiteAlright got to my channel for repair 👨‍🔧 video

@tgoodm1 3 жыл бұрын

QuiteAlright Hello!!! Do you have an email address?

@fuckwitpeoria 3 жыл бұрын

@@tgoodm1 sweet4726@gmail.com