Рет қаралды 52,971
Wanting to use flat flex cables, I need to solder the fine pitch connectors to the break out boards so I can use them in prototyping.
Drag soldering with lots of flux allows the 0.5mm pitch headers to get soldered easily.
Workbench equipment I regularly use:
946C Solder Hot Plate 200mm x 200mm www.banggood.com/custlink/K3D...
ANENG AN8008 True RMS Multimeter www.banggood.com/custlink/KKD...
Minleaf NPS3010W Power Supply www.banggood.com/custlink/KKK...
FY6900 Dual Channel 60MHZ Signal Generator www.banggood.com/custlink/vGK...
Siglent SDS1104X-E 100Mhz Digital Oscilloscope 4 Channels Standard decoder
Amazon.com: amzn.to/36fH1ui
Amazon.ca: amzn.to/36fNWUc
(These are affiliate links. I may earn a commission if you shop through the links, it supports the channel and doesn't cost you extra)
Support me on Patreon: / gadgetreboot