Another nice motor coming together Phil. You are certainly getting the pick of the nice colours for your recent cars. Better to have some fresh oil in the gearbox than messing about to save it. 😂
@SuperMinimadness Жыл бұрын
Hi Phil I would have changed the drive shaft on the ground with the passenger side on blocks and the drivers side about six inches higher so the oil could not run out.
@darrenjones9504 Жыл бұрын
Should be a nice car when it’s finished 👍👍
@rosswalker3284 Жыл бұрын
Whats a bit of oil, all the other money you spend ..Should have let drain an refilled with fresh...glory glory mush
@MartinJones-tl9kt Жыл бұрын
That hub can't be right if it ain't got threaded holes for backplate
@martynpanting Жыл бұрын
If you notice around 13:15, the Timelapse is cut where he puts the heat shield on. I guess there was some sketchy sht going on to attach it…
@SeriousAboutSalvage Жыл бұрын
@@martynpanting sketchy shit? I drilled and tapped 3 holes just like the original one had, in the exact same place on the casting where its designed to have the holes. There's nothing sketchy about that, but it takes time and I get moaned at for too much time lapse , so what am I supposed to do?
@Joe-ug3dd Жыл бұрын
The man said near the beginning that he would drill and tap the holes needed, which he obviously did 🤷
@peterlockyer1348 Жыл бұрын
great video as always looking forward to the next episode 👍❤😊
@normanstephens5391 Жыл бұрын
Well done Phil. Your getting there, as usual. I quite like the car . Although a person local to me regrets buying his. Due to the low mpg he gets from it. Been back to Ford Dealer 4 times and no improvement.. See you in the next one. 🛠🛠
@mrmawson2438 Жыл бұрын
Great teacher
@ragnarironspear1791 Жыл бұрын
Alway enjoy your videos 👍🏻🇬🇧
@paultaylor9652 Жыл бұрын
I kinda like the Ecosport, but under the arches it looks rough for the mileage and age. My wife had a Fiesta 17 plate and it didn't look like this car, I wonder if its been a country car using lanes etc.
@optic1972 Жыл бұрын
I'm not sure if you have ever tried to remove a polycarbonate lens from a headlamp housing? Having worked for 4 lighting manufacturers I would be truly amazed if you do it! It's a 2 part cure adhesive which is designed to not go anywhere, I'm now watching in anticipation 😊
@stephenfarrow368 Жыл бұрын
Looking forward to this rebuild phil
@keithgoodway9077 Жыл бұрын
you can't be ill, your self employed, your not a civil servant, nice work on the eco sport as always.
@mrmawson2438 Жыл бұрын
Great video mate
@a11csc Жыл бұрын
getting there
@user-be7vq9tz3f Жыл бұрын
Loving the series, what's happening with the two white cars??
@steveholmes9016 Жыл бұрын
Love channel but less waffle more content if you watch your own vid you will see what I mean